User's Manual

User manual
This device has only one button to operate.
And only thing user can operate on this device is press the button.
We make it super simple to use.
When press the button, it can make a phone call.
Short press the blue button to wake up the system, and long press for 4
seconds will make emergency call.
With a pin to press the pinhole can close the unit.
When unit is off, long press the blue button for 6 seconds to turn on the device.
User can press the button quickly to find the following information:
1. If the red light blinks 1 time, the device is powered on and in standby
mode.
2. If the red light blinks 1 time and blue light blinks for 10 seconds, the device
is on.
3. If no light blinks, the device is off
Put the device to the charger cradle, the device will be charged.
FCC Warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the users authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and

Summary of content (2 pages)