USER’S MANUAL 802.11b/g/n 2T2R Wireless LAN USB Module WN4646L ICM S.B.U. LITE-ON Technology Corporation 11F, 392, Ruey Kuang Road, Neihu, Taipei 11492, Taiwan, R.O.C.
PRODUCT FEATURES Operate at ISM frequency Band (2.4GHz) IEEE Standards Support, 802.11b, 802.11g and 802.11n CMOS MAC, Baseband PHY, and RF in a single chip for IEEE 802.11b/g/n compatible WLAN Complete 802.11n MIMO solution for 2.4GHz band Complies with USB Specification 2.0, support Full-speed(12Mbps) and High-Speed(480Mbps) Enterprise level security supporting: IEEE 802.11i (WPA, WPA2).
PRODUCT SPECIFICATIONS MAIN CHIPSET Realtek RTL8192FC FUNCTIONAL SPECIFICATIONS Wi-Fi Function Standard IEEE802.11b; IEEE 802.11g; IEEE 802.11n Bus Interface USB 2.0 Data Rate 802.11b: 11, 5.5, 2, 1 Mbps 802.11g: 54, 48, 36, 24, 18, 12, 9, 6 Mbps 802.11n: MCS 0 to 7 for HT20MHz MCS 0 to 7 for HT40MHz Media Access Control CSMA/CA with ACK Modulation Techniques Network Architecture Operation Channel Frequency Range 802.11b: CCK, DQPSK, DBPSK 802.11g: 64QAM, 16QAM, QPSK, BPSK 802.
802.11n HT40 Tgtpwr (dBm) 14 14 14 MCS0 MCS1 MCS2 MCS3 MCS4 14 14 14 14 14 MCS5 MCS6 MCS7 14 14 14 Receiver Sensitivity Frequency Band 2.4G Rate Condition 11b-1M 11b-11M 11g-6M 11g-54M 11n-HT20 MCS0 11n-HT20 MCS7 11n-HT40 MCS0 11n-HT40 MCS7 PER < 8% PER < 8% PER < 10% PER < 10% PER < 10% PER < 10% PER < 10% PER < 10% 1x1(1SS) (dBm) -92 -85 -90 -71 -90 -70 -87 -67 Security WEP 64&128 bit, WPA, WPA-PSK, WPA2, WPA2-PSK, WPS, IEEE 802.1X, IEEE 802.
RECOMMENDED OPERATION CONDITIONS Symbol Min Typ Max Units 5V Supply Voltage 4.5 5 5.5 V VDD33 3.3V I/O Supply Voltage 3.0 3.3 3.6 V VDD10 1.05V Core Supply Voltage 0.95 1.05 1.15 V Typ Max Units VCC Rating DC CHARACTERISTICS Symbol Parameter in VIL Input Low Voltage - 0 0.9 V VIH Input High Voltage 2.0 3.3 3.6 V VOL Output Low Voltage 0 - 0.33 VOH Output High Voltage 2.97 - 3.3 RESET TIMING SPEC Symbol Min Typ Max Units Ton 0.25 1.
PIN ASSIGNMENT Pin.
EEPROM INFORMATION Reg Domain Worldwide Channels 1-13 with active scan 0x20 Vendor ID 0x0BDA Device ID 0xF192 ENVIRONMENTAL OPERATING Operating Temperature: 0 to 70 °C (32 to 158 °F) Relative Humidity: 5-90% (non-condensing) STORAGE Temperature: -25 to 75 °C (-13 to 167 °F) Relative Humidity: 5-95% (non-condensing) Page 7/9
WARNINGS Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
configurations with respect to Part 2.1093 and different antenna configurations The information on how to configure test modes for host product evaluation for different operational conditions for a stand-alone modular transmitter in a host, , versus with multiple, simultaneously transmitting modules or other transmitters in a host can be found at KDB Publication 996369 D04 Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment authorizations (e.g.