User's Manual

ManualsBrandsLITE-ON ManualsElectronics802.11a/b/g/n 2Tx2R USB WLAN Module

Table Of Contents

Page 1/14

USER’S MANUAL

802.11a/b/g/n 2Tx2R USB WLAN Module

WCBN3509R(38)

Summary of content (14 pages)

PAGE 1
USER’S MANUAL 802.
PAGE 2
PRODUCT FEATURES WI-FI FEATURE:      Operate at ISM frequency Band (2.4/5GHz) IEEE Standards Support, 802.11a ,802.11b, 802.11g, 802.11n Support for both 20 MHz, 40MHz channel width in 2.4GHz and 5GHz band Enterprise level security supporting: WPS2.
PAGE 3
PRODUCT SPECIFICATIONS MAIN CHIPSET MediaTek MT7638BU FUNCTIONAL SPECIFICATIONS Wi-Fi Function Standard IEEE802.11a; IEEE802.11b; IEEE 802.11g; IEEE 802.11n Bus Interface USB2.0 Data Rate 802.11a: 54, 48, 36, 24, 18, 12, 9, 6 Mbps 802.11b: 11, 5.5, 2, 1 Mbps 802.11g: 54, 48, 36, 24, 18, 12, 9, 6 Mbps 802.
PAGE 4
2.4GHz 802.11b Tgtpwr (dBm) 1Mbps 16 2Mbps 16 5.5Mbps 16 11Mbps 16 802.11g Tgtpwr (dBm) 6~24Mbps 15 36Mbps 15 48Mbps 15 54Mbps 15 802.11n HT20 Tgtpwr (dBm) 802.11n HT40 Tgtpwr (dBm) MCS0 MCS1 MCS2 MCS3 MCS4 15 MCS5 15 MCS6 15 MCS7 15 MCS8 15 MCS9 15 15 15 MCS0 MCS1 MCS2 MCS3 MCS4 15 MCS5 15 MCS6 15 MCS7 15 MCS8 15 MCS9 15 15 15 5GHz 802.11a Tgtpwr (dBm) 802.11n HT20 Tgtpwr (dBm) 802.11n HT40 Tgtpwr (dBm) 6~24Mbps 14 2.
PAGE 5
Security 11ac-VHT20MCS0 PER < 10% -85 11ac-VHT20MCS7 PER < 10% -68 11ac-VHT20MCS8 PER < 10% -65 11ac-VHT40MCS0 PER < 10% -82 11ac-VHT40MCS7 PER < 10% -65 11ac-VHT40MCS9 PER < 10% -61 11ac-VHT80MCS0 PER < 10% -80 11ac-VHT80MCS7 PER < 10% -63 11ac-VHT80MCS9 PER < 10% -57 WPS, WPA, WPA2, WEP 64bit & 128bit, IEEE 802.1X, IEEE 802.11i Common Function Operating Voltage 3.3 V ±10% I/O supply voltage Mode Power Consumption TX RX Unassocia ted Idle Antenna Type Average 2.
PAGE 6
RECOMMENDED OPERATION CONDITIONS Symbol Rating Min Typ Max Units VDD33 3.3V Supply Voltage 2.97 3.3 3.63 V VDD12 1.2V Supply Voltage 1.14 1.2 1.26 V VDD15 1.5V Supply Voltage 1.425 1.5 1.575 V Min Typ Max Units DC CHARACTERISTICS Symbol Parameter VIL Input Low Voltage -0.28 - 0.6 V VIH Input High Voltage 2.0 - 3.63 V VOL Output Low Voltage -0.28 - 0.4 V VOH Output High Voltage 2.4 - 3.
PAGE 7
PIN ASSIGMENT Pin. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Pin Define Description +3.3V 3.3V source +3.3V USB_D- 3.
PAGE 8
MECHANICAL Page 8/14
PAGE 9
EEPROM INFORMATION WI-FI Reg Domain World Wide 2.4G/5G Read from registry; Control by driver Offset 0x38 for 5G: 0xFF Offset 0x39 for 2.
PAGE 10
WARNINGS FCC Statement: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 11
Page 10/15 IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. IMPORTANT NOTE: This module is intended for OEM integrator. The OEM integrator is responsible for the compliance to all the rules that apply to the product into which this certified RF module is integrated.
PAGE 12
1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1.
PAGE 13
5470-5725 MHz doit se conformer à la limite de p.i.r.e. Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance sont désignés utilisateurs principaux (c.-à-d.
PAGE 14
environment can be satisfied. The end user has to also be informed that any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. The transmitter module may not be co-located with any other transmitter or antenna.