User Manual DS4028_WS4SC
Table of Contents Federal Communication Commission Interference Statement .. 1 Introduction .............................................................................. 2 Button and LED ........................................................................ 3 How to Power On the Device ................................................... 3 How to Power Off the Device ................................................... 3 How to Reset the Device ..........................................................
D S 4 0 2 8 _ W S 4 S C Federal Communication Commission Interference Statement pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Introduction DS4028ST Device is a container tracker with Sigfox. Powering on, the device will spend 5 minutes scanning the Sigfox Monarch signal in order to identify the current geographical zone. It will collect environmental data and send it out periodically with Sigfox. The collected data is such as temperature and humidity. The device can be known where it is through the location of the Sigfox radio station.
Button and LED Screw hole How to Power On the Device Long press the Power Button over 5 seconds until the White LED is flashing. How to Power Off the Device Long press the Power Button over 5 seconds until the Red LED is flashing. How to Reset the Device Press the User Button and the Power Button together. How to install the Device The full pack includes 2 magnet sets to be locked via screw hole and absorb onto any metal surface users want.