FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed or used in accordance with the instructions, may cause harmful interference to radio communications.
[ENE | HARDWARE INSTALLATION Turn off your PC and disconnect all power cords, Refer to your PC user's manual to remove the PC cover. Set up your CD-ROM to Master or Slave device according to the following section Find an empty bay, sited the CD-ROM into the bay and mount the drive by using 4 Crews Connect the power cable to your CD-ROM drive. NOTE: The pin definition of power connector should be the same as that in figure I.
ENGLISH Connect to Primary/Secondary IDE Port In most of the PC systems, the hard disk will be in Primary DE port and Master device for the PC to boot the operating system. CD-ROM drive should be set to Slave device if you need to connect your CD-ROM to the same Primary {DE port. In some situations, you may need to connect your CD-ROM drive to Secondary [DE port if the Primary [DE port is occupied.
ENGLISH SOFTWARE INSTALLATION There is a device driver diskette in your CD-ROM drive package. The device driver is needed if your PC system is in DOS or Windows 3.1 or higher. Please follow the procedures listed below if you need to install the device driver in your system. Usually the device driver 1s not necessary if you run the Windows 95, Windows NT, or 08/2. Please refer the following procedures or the user's guide of the operating system if the CD-ROM can't be recognized automatically.
ENGLISH U Sing THE CD-ROM DRIVE Earphone Jack © Volume Knob & On/Busy LED “3 Door «d Emergency Eject NOTE: & Play/Skip = @ Open/Close/Stop The user can use a stereo headphone to get sound output from the earphone jack. The user can adjust this knob to change the volume of earphone. The On/Busy LED will be flashing while the CD-ROM disc is busy. The user can open or close the Door by pressing the Open/Close Burton. If the user can not jet the disc by pressing the Open/Close button.