CM22 434MHz R.F.
1. Kit Contents 2. Installation IMPORTANT SAFETY CAUTION IF IT IS NECESSARY DISARM OR REMOVE AN SRS AIRBAG, MANUFACTURER’S PROCEDURE MUST BE FOLLOWED. FAILURE TO DO SO MAY RESULT IN AIRBAG DEPLOYMENT AND POSSIBLE INJURY OR DAMAGE TO VEHICLE. INSTALLATION PROCEDURE NOTES—The switch must be fitted to the right side of the steering wheel as the buttons are not reversible. The battery supplied in the hardware is a spare to be given to the owner of the vehicle. The switch already contains a long life battery.
The cruise engage LED will show a dull glow when Cruise Control is off and ignition switch is on. This will assist the LED location during night time driving. Note: The red LED indicator in the middle of transmitter module will illuminate when any button is pressed. It will flash with 5 times when it is at low battery condition. You have to replace battery as soon as possible (Spare battery supplied – model CR2032). 3.
the LED will display a Green colour, when ENGAGED it will display an Orange colour. ON/OFF BUTTON This button turns the Cruise Control ON or OFF. Status LED will change colour as detailed above. SET/ACC BUTTON (Set/Accelerate Functions) This button has 2 functions. When the Cruise Control is in standby (Green LED) pressing this button will SET (engage) the Cruise Control at your current speed. When the Cruise Control is engaged (Orange LED) pressing this button will ACCELERATE (increase) the speed.