User Manual

ManualsBrandsLionel ManualsAccessoriesLionel O36 Manual Switch, Left Hand

Joining the FasTrack track sections

asTrack track sections join together easily. With interlocking roadbed sections and large rail

tabs, the track fits together securely so you always get good electrical contact. Take a look at

Figure 1 to see how to join the track sections.

1. Line up your two sections of track.

2. Insert the rail tabs into the openings at the ends of the corresponding rails.

3. Press the sections together until the interlocking roadbed snaps into place.

Figure 1. Joining the track sections

Rail tab

ongratulations on your purchase of the Lionel FasTrack Manual Switch! This switch is controlled

by rotating the switch stand. Use this switch to join two loops, create a switching yard, or add a

siding.

The following Lionel marks may be used throughout this instruction manual and are protected under law.

Lionel

, TrainMaster

, Odyssey

, RailSounds

, CrewTalk

™

, TowerCom

™

, DynaChuff

™

StationSounds

™

, Pullmor

, ElectroCoupler

™

, Magne-Traction

, CAB-1 Remote Controller

PowerMaster

, Lionel ZW

, ZW

, PowerHouse

, TMCC

, Lionelville

™

, Lockon

The name FasTrack

is used with permission from Pitsco, Inc.

Manual Switch

71-2017-250

8/03

Summary of content (4 pages)

PAGE 1
71-2017-250 8/03 Manual Switch ongratulations on your purchase of the Lionel FasTrack Manual Switch! This switch is controlled by rotating the switch stand. Use this switch to join two loops, create a switching yard, or add a siding. C Joining the FasTrack track sections asTrack track sections join together easily. With interlocking roadbed sections and large rail tabs, the track fits together securely so you always get good electrical contact.
PAGE 2
Throwing the switch s illustrated in Figure 2, rotate the top of the switch stand to throw the switch. This switch is equipped with a non-derailing feature. The train’s wheels automatically throw the blades to the proper position when the train travels toward the converging track. If you experience difficulties, simply throw the switch into the correct position for the train to travel using the switch stand control. A Switch target Blades Switch handle Figure 2.
PAGE 3
Changing the switch stand location Y ou may choose to position the switch stand either inside or outside the loop of track. Follow these steps and refer to Figure 3 to change the location of the switch stand. 1. Remove the two screws that secure the small roadbed section to the switch and lift away the roadbed section. 2. Place the “blades,” or moving rails, in the proper position to make removing the switch stand roadbed section easier.
PAGE 4
Limited Warranty/Lionel Service his Lionel product, including all mechanical and electrical components, moving parts, motors and structural components, except for light bulbs, is warranted to the original consumer-purchaser, for one year against original defects in materials or workmanship when purchased through an authorized Lionel merchant.