Recharging the Battery Pack Battery Type Use the following type and size of battery pack: Cordless Telephone Battery Pack 3.6V, 600mAR U.S. Electronics Inc. Ni-Cd Battery Pack: model B650 This battery pack is available through: U.8. Electronics Service Center 105 Madison Avenue New York, NY 10016 1-800-828-5208 Recharging the Battery Pack The nickel cadmium (Ni-Cd) battery pack in the HANDSET can be recharged many times using the built-in charger in the BASE UNIT.
Changing the Battery Pack The battery pack provides power for the HANDSET of your cordless telephone. To Replace the Battery Pack: 1. 5. Remove the HANDSET battery compartment cover by sliding it down. 2. Pauli out the battery connector and remove the battery pack. 3. 4. Slide the HANDSET battery compartment cover firmly into place in its closed Plug the new battery pack into the battery connector. position. Before use, charge the new battery pack for 12 hours.
Problem Solving Problem Solving Section For your assistance, we have listed below a few common problems. Phone does not work, check the following: 1. BASE UNIT is plugged into power source. 2, HANDSET is charged. 3. TONE/PULSE switch is in the right position. 4. TELEPHONE LINE CORD is plugged into the telephone jack. Range of phone limited, check the following: 1. ANTENNA on BASE UNIT is raised. 2. BASE UNIT is centrally located in your residence, 3. BASE UNIT is rot located near appliances.
Technical Information This cordless telephone uses radio frequencies to allow mobility, There are certain difficulties in using radio frequencies with cordless telephone. While these are normal, the following could affect operation of your system. Noise Electrical pulse noise is present in most homes at one time or another. This noise is most intense during electrical storms. Certain kinds of electrical equipment such as light dimmers, fluorescent bulbs, motors, and fans also generate noise pulses.
| FCC Requirements Federal Communications Commission Requirements This equipment complies with Part 88 of FCC Rules. A label on the BASE UNIT of this equipment contains, among other information, the FCC Registration Number and the Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this information to your telephone company.
CC Requirements Federal Communications Commission Requirements (continued) Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference ina residential installation.
Warranty Information Bell South Products One-Year Limited Warranty This limited warranty sets forth all Bell South Products responsibilities regarding your product. There are no other expressed or implied warranties from Bell South Products. Warranty Service Provided If you purchased the new telephone from a retail vendor, Elisabeth Products warrants the telephone against defects in material and workmanship for a period of one (1) year from the original date of purchase.
What to Do for Warranty Service During the first thirty (30) days, a defective product is eligible for over-the-counter exchange at the retailer from whom it was purchased. After thirty (30) days, the defective product should be returned to the authorized service center. Please allow 2-3 weeks for the return of your telephone product. The shipping address of the authorized service center is: U.S.
~ This page serves as a temp late for attachment of screws to the wall when mounting this telephone on the wall. 1. Cut out this page. LL | 2. Use this template to determine the distance between screws i when mounting this phone on the wall. The two cross hairs identify where to attach the screws.
IMPORTANT In order to get maximum fife from the HANDSET battery pack, be sure to charge the HANDSET for 12 hours before initial use. IMPORTANT Placing your BASE UNIT near appliances such as televisions, refrigerators, radios, or microwave ovens may cause interference. IMPORTANT When you hear interference, press the (5D) button to change the operating channel. IMPORTANT The AC ADAPTER must always be plugged into an electrical outlet.
Make certain you receive the best performance from your telephone. Read this manual first.