“press the RESET button Setting the Day/Time Stamp «Press and hold down the =n button until you hear the announcement “Please enter the day and time." Then, enter the current day and ime. + 1. Day Setting Press and hold down ihe The corresponding day will be displayed and announced. Release the button when the desired day is mentioned. . Hour Setting Press and hold down the The corresponding hour will be displayed and announced. Release the bunion when the desired hour Is mentioned. 3.
completing your OGM, release the announce, ‘End of Recording.” Your recorded message will be played back for your approval. NOTE: Your OGM must be at least 3 seconds and no more than 30 seconds in length. If you wish to change your OGM, repeat steps 1 through 2. : NOTE: To obtain a better sound “quality for locally recorded (Ohms and Memos) messages, speak directly into the MICROPHONE from a distance inches.
Nora a mailbox, press a mailbox button and then press e ein do not have an OGM in a mailbox, It will announce have-no-announcement, MAILBOX #" Ones 8 mailbox 1s activated, its corresponding MAILBOX LED Indicator blinks slowly to show that the mailbox is active. If you do not press a bunion to activate another function within 10 seconds, the Answering System will return to the PRIMARY MAILBOX. You may return to the PRIMARY MAILBOX at anytime by pressing the 2 button.
Screening Incoming Calls ~~ ~ The Ans: g System allows fourteenths to a Answering System starts answering a call, press the ich button for listening only and the Answering System will continue to record. If you want to talk to the caller, press the ficus button again then press the button and the Answering System will stop recording and you may talk to lhe caller.
3. Begin speaking immediately after you he: lease. record. yogurt-message-after— «+ the beep.” Continue to depress the button. One second after completing your Memo; release the [DUO and you will Kara, “End of Recording.” Day and time are automatically stamped at {he end of the message. NOTE: The Answering System advances the message count automatically after the actual message is recorded.
Saving Messages tee “The Answering. System faves. your message: automatically, After all 0 messages, the Answering System announces, “End of message” and total number of messages stored In the memory will be indicated on the LED Message Display. NOTE: The Answering System has a {ital Memory capacity of 12 minutes messages (OCMICM/MEMO). If ihe recorded messages contain high background noise, the total recording capacity of the unit will be less than 12 minutes. Erasing Messages A.
Remote Control Operation _The Answering System. can be operated threw a HANDSET or away from your home through a Touchstone: telephone. . Remote Operation through the HANDSET You ean operate your Answering System via remote control using the HANDSET, 1. Press the button at the STANDBY mode, to activate the REMOTE CONTROL function. The BASE UNIT LED Message Display will show 2.. Press the corresponding number of the function you wish to activate. A. Press the § button fo play messages. . B.
Answering System Operation [Remote Operation through a Tories Telephone ._ _. You can use many Answering System features when you are away from home. To protect your privacy, most of the features can be used only after nourishment ie three-digit Remote Access Code. Remote Access Codes The Remote Access Codes are preset at the factory as shown below. You can use the preset codes or choose your own. PRIMARY MAILBOX: 998 MAILBOX 1: 555 MAILBOX 2: £66 MAILBOX 3: 777 .
Using the Remote Instruction Code Cl — . Dial your telephone number. : 2. Listen to or bypass ihe OGM in the PRIMARY MAILBOX. 3. Enter your Remote Access Code. If the announcement does not stop, enter the Remote Access Code again. . The Answering System will request that you enter the instruction Code or press Ed button foc help. A. If you da riot know the Instruction Code, press button immediately. The Answering System will announce the Instruction Codes.
Security Security : Your cordless telephone used a digital coding security system to prevent unauthorized use of your telephone line by another nearby cordless telephone. The system has fis own identifying signal created by microcomputers in both the BASE UNIT and the HANDSET. Security Code This telephone has an internal security code with 85,536, possible combinations.
Use thee following type and size of BATTERY PACK: Cordless Telephone BATTERY PACK 3.8V, B00mAh U.S. Electronics inc. Ni-Cd BATTERY PACK: Model B650 Ni-Cd This BATTERY PACK is available through: U.S. Electronics Service Center co 105 Madison Avenue New York, NY 10016 1-800-828-5208 Recharging the BATTERY PACK The nick! cadmium (Ni-Cd) BATTERY PACK in the HANDSET can be recharged many dimes using the built-n charger in the BASE UNIT. .
Changing the BATTERY PACK Changing the BATTERY PACK: Lr ee The BATTERY=PACK provides power for the HANDSET of your cordless telephone. To Replace the BATTERY PACK: 1. Remove the HANDSET BATTERY COMPARTMENT COVER by sliding it down. 2. Pull out the BATTERY PACK PLUG and remove the BATTERY PACK. ~ 3. Plug the new BATTERY PACK into the BATTERY CONNECTOR. 4, Slide the HANDSET BATTERY COMPARTMENT COVER firmly into place n I” its closed ’ position. 5. "Before use, charge the new BATTERY PACK for 12 hours.
Problem Solving Section stance, we have listed v a few common problems. Phone oes not work, check the foll following: 41. BASE UNIT is plugged into a power source. 2. HANDSET is charged. s 3. TONE/PULSE Select Switch is in the right position. 4. TELEPHONE LINE CORD Is plugged into the TELEPHONE JACK. Range of phone limited, check the following: 4. ANTENNA oii the BASE UNIT is raised. 2. BASE UNIT is centrally located in your residence. 3.
1. BASE UNIT is plug 2. "Reset the stent’ "RESET button at ii side of the BASE UIT ™ Answering System does not answer calls, check the following: 1. ANSWER ON/OFF LED indicator is fit Answers calls only after 10 rings, check the following: . 1. ANSWER ON/OFF LED indicator is fit. 2. Message Memory Is not full. Does not respond fo remote commands, ensure the following: 1. Correct Remote Access Code is entered. 2. ATONE telephone is being used. Messages are incomplete, ensure the following: 1.
~Technical Information ~~ + His-cordless telephone There are certain difficulties in using radio frequencies with a cordless telephone. While these are normal, the following c could affect the operation of your system. Noise Electrical pulse noise is present in most homes at one time or another. This noise is most intense during electrical storms. Certain kinds of electrical equipment such as light dimmers, fluorescent bulbs, motors, and fans also generate noise pulses.
FCC Requirements Federal Communications Commission Requirements This equipment, complies with. Part 68.0f the FCC Rules. A label on the. BASE UNIT of this equipment contains, among other information, the FCC Registration Number and the * Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this information to your telephone company.
EE Federal Communications Commission Requirements (continued) ad DENOTE: This Supplement hae Beer tested and found to comply with the fits far class B digital device, pursuant fo Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Warranty Warranty Information Bell South Products One-Year Limited Warranty A This limited warranty sets forth all Elisabeth Products responsibilities regarding your product. There are no other expressed or implied warranties from Bell South Products, Warranty Service Provided Pon if you purchased the telephone new from a retail vendor, Southerly Products warrants the telephone against defects in material and workmanship for a period of.one (1) year from the original date of purchase.
x Wall Mount Template This page serves as a template for attachment of craws to the wail when mounting this telephone on the wall. 1. Cut out this page. 2. ‘Use this contemplate determine the distance between screws when mounting his phone on the wail, The two cross hairs.
IMPORTANT In order to get maximum life from the HANDSET BATTERY PACK, be sure to charge the HANDSET for 12 hours before initial use. IMPORTANT Placing your BASE UNIT near appliances such as televisions, refrigerators, radios, or microwave ovens may cause interference. « IMPORTANT When you hear interference, press the : + button to change the operating channel. ) NY The AC ADAPTER must EVERETTE | into an electrical outlet.
ee ee een Make certain you receive the best performance from your telephone. Read this manual first.