BASE UNIT Controls 1. TELEPHONE LINE CONNECTION JACK 2. POWER-IN CONNECTION JACK 3. TONE PULSE Select Switch 4. PAGE Button: Press to page the HANDSET. Press again to stop. 8. ANTENNA: Raise or reposition for the best reception, 8. . IN USE/CHARGE LED Indicator: Lights up when the HANDSET is in TALK mode or when the HANDSET is spiced on the BASE UNIT for charging. .
5% Getting Started 20 Ec! Connecting Your Phone This section is a reference guide to the basic functions and operations of your cordless telephone. For more detailed descriptions of the operations and features of this: telephone, refer to the Contents on page 1 1 Ne Carefully remove your cordless telephone from its shipping carton. If there is any visible damage, do not attempt to operate this equipment. Return i fo the place of purchase. .
8. 10. 1M. BASE UNIT BASE UNIT ANTENNA TELEPHONE LINE CONNECTION JACK SWITCH 5 AL ADAPTER Install the HANDSET BATTERY PACK by plugging it into the BATTERY CONNECTOR inside the BATTERY COMPARTMENT. Place the BATTERY PACK inside the BATTERY COMPARTMENT. Tide the HANDSET BATTERY COMPARTMENT COVER firmly into place nits closed position TONE/PULSE Select Switch: A. If your home is equipped with a tone dialing system set the TONE/PULSE Select Switch to the TONE position. B.
Getting Started Press the button fo confirm that you have a dial tone. If you do not get a dial tone, review steps 3 through 11. if you steel do not have a dial tone, refer to the Problem Solving section on page 20. With the back of the HANDSET facing up, insert one side of the BELT CLIP HOOK into the matching slot at the top side of the HANDSET. Press down on the opposite side of the BELT CLIP until the other hook locks into the soot on the side of the 5 HANDSET 12.
Desk Mounting Desk Mounting One of the special features of your equipment is the unique design of the MOUNTING BRACKET which can hold your phone at an angle of 30° when desk mounting. “There are two positions to choose from: 1. NORMAL POSITION (MOUNTING BRACKET not required): For normal position, as shown in Figure 1, place the BASE UNIT on any desired but suitable location. FIGURE 1 2.
1 Wall Mounting Wall Mounting You may choose to put the BASE UNIT of your cordless telephone on a wall, 1. With the back of the BASE UNIT facing up, connect the SHORT TELEPHONE LINE CORD to the TELEPHONE LINE CONNECTION JACK, 2. Feed the SHORT TELEPHONE UNE CORD into the groove. on the back of the BASE UNIT then inset: the free end of the SHORT TELEPHONE LINE CORD through the hole of the MOUNTING BRACKET. 3.
Basic Operation Preparing for Use Before you can use your cordless telephone, you must charge the HANDSET for 12 hours. Failure to do so will require recharging of the BATTERY PACK more often. 1. Place the HANDSET on the BASE UNIT for 12 hours. 2. After 12 hours, remove the HANDSET from the BASE UNIT. 3. Raise or reposition the BASE UNIT ANTENNA for the best reception. Be fare you can use your cordless telephone, you must charge the HANDSET for 12 hours.
Receiving Calls with the HANDSET on the BASE UNIT 1. When the phone rings, ift the HANDSET. The IN USE LED indicator will light up. NOTE: The HANDSET RINGER ON/OFF OFF switch must be in the “RINGER ON™ position for finger to operate. 2. Start your conversation. 3. To end your conversation, either press the: button or place the HANDSET on the BASE UNIT. If you place the HANDSET on the BASE UNIT charge cardie, you activate the automatic STANDBY feature Receiving Calls with the HANDSET off the BASE UNIT 1.