SURETALK USERS GUIDE 1
Suretalk Users Guide CHARGING ONLY [no RF communications]: • • • • Power up either the Charger Base or the RF Charger BaseStation. Insert RF Microphone fully. Charger Base/RF Charger BaseStation LED changes from red (charge done) to yellow (charging). Charging cycle is complete when red (charge done) LED is lit. NORMAL OPERATION: Cradle Sync • • • • • Power up RF Charger BaseStation. SYNC LED on RF Charger BaseStation flashes slowly. Insert RF Microphone fully.
RF Sync. • • • Remove RF Microphone from BaseStation. SYNC LED on RF Charger BaseStation and ACT LED on RF Microphone flash quickly, then very rapidly. The COMM LED on the RF Microphone will flash, indicating RF Microphone <> RF Charger BaseStation RF communications, establishing an RF link. The ACT LED on the RF Microphone now flashes very slowly, approximately once every three seconds. This is RF Microphone Active Standby mode. Switch-On (activation).
ORDER OF OPERATION: (refer to pages 1 and 2 for details) 1. If RF Microphone appears to charge and cradle-sync, but does not RF Sync – the battery may require charging. 2. Perform Cradle Sync. 3. Perform RF Sync. 4. System is ready for use – refer to Normal Operation. FCC NOTICE This device complies with Part 15 of the FCC Rules.