Instructions / Assembly

Power input: 125V/60Hz
Power output: 1875W/15A (Max.)
Transmitter frequency: 433.92MHz
Remote transmitter battery: DC CR2032, 3V battery 1pc
Transmission range: up to 100ft
Caution
1. Appliance to be connected to the remote control socket
MUST NOT exceed the voltage and frequency ratings as
in “Specifications”.
2. Install the cord and unit above ground level at least 5ft
with the receptacle facing downward.
3. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
(2) this device must accept any interference received, including
interference that may cause undesired operation.
4. Both for indoor and outdoor use and storage.
Do not immerse into the water.
5. Weather, radio frequency interference;
6. Low transmitter battery may lower the distance
between the transmitter and the receiver.
EM-OR700B
30UL/MRF+EMW301TK
Wireless Remote Control Outlet Oudoor
with Countdown and Photocell 1+1
Instruction manual
4
3
Remove the plastic battery tab from the battery compartment
in the back of the remote control to activate the pre-installed
battery.
1.
2.Plug the receiver into a standard AC electrical wall socket.
Plug the appliance into the receiver outlet.
OFF mode on the dial will manually turn OFF device.
ON mode on the dial will manually turn ON device.
DUSK/DAWN mode: Integrated photocell sensor will automatically turn
ON device at dusk and turn OFF device at dawn.
COUNTDOWN DUSK/DAWN mode: Integrated photocell sensor will
automatically turn ON device at dusk for selected 2HR/4HR/6HR/8HR
and turn OFF device after countdown period has ended.
4. Before using the outlet with remote control, please pair as follows:
Plug in the outlet into a grounded outdoor wall socket. When the receiver
indicator light begins flashing, long-press the ON or OFF button on the
remote control. The pairing appears successful when the receivers indicator
light stops flashing.
Unpairing: When the remote control and outlet are connected, unplug the
receiver from the grounded wall socket, then plug-in the receiver.
The indicator light will begin flashing. Long-press the ON or OFF button to pair.
3.
A.
B.
OFF
ON
OFF
ON
1
OFF
ON
2
LINK2HOME
1 YEAR LIMITED WARRANTY
IMPORTANT: Proof of Purchase is required to obtain
warranty service
Paragon Group USA Inc. warrants to the original owner that
our products will be free from defect in workmanship and
material for a period of ONE YEAR from the date of purchase.
Should any unit(s) prove to be defective during this period,
Paragon Group USA Inc. will be responsible for replacement
of the defective unit(s) only. Paragon Group USA Inc. is not
responsible for labor charges or any incidental or consequential
expenses.
Not Covered – Batteries are not covered by this warranty.
Repair service, adjustment and calibration due to misuse,
abuse or negligence are not covered by this warranty.
Unauthorized service or modification to this product or of any
furnished components will void this warranty in its entirety.
link2home.com
This warranty does not include reimbursement for inconvenience,
installation, set-up time, loss of use, postage, unauthorized
service, or other products used in conjunction with Link2Home
products.
For warranty service, please contact Paragon Group USA Inc.
Customer Service by Phone: [phone] or
e-mail: [e-mail].
This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
Paragon Group USA Inc.
Link2Home Product Division
Englewood, NJ 07631
USA
Remote Battery Replacement:
If operation of the receiver units becomes erratic, it may be necessary to
replace the battery in the hand-held remote unit. To do this, first remove
the battery compartment cover. Press the tray release button on the back
of the remote. Next, remove the depleted battery and discard according
to local ordinances. Be sure the correctly install the new battery. Replace
battery compartment cover and test by using it to control the Indoor
Remote Outlets.
Important: Install only new batteries of the same type in your product.
Failure to insert batteries in the correct polarity, as indicated in the battery
compartment, may shorten the life of the batteries or cause batteries to leak.
Do not mix old and new batteries. Do not mix Alkaline, Standard (Carbon-Zinc)
or Rechargeable (Nickel Cadmium)or (Nickel Metal Hydride) batteries. Danger
of explosion if battery is incorrectly replaced.
Batteries should be recycled or disposed of as per state and local guidelines.
WARNING: This product contains a button battery. If swallowed, it could
cause severe injury or death in just two hours. Seek medical attention
immediately.