® Relay™ TBP12 Pilot’s Handbook Manuel de pilotage Pilotenhandbuch Pilotenhandboek Manual del Piloto 取扱説明書 See www.line6.com/manuals for Advance Guide 40-00-0239 Advanced Users Guide available @ www.line6.
Important Safety Instructions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE. CERTIFICATION THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
You should read these Important Safety Instructions. Keep these instructions in a safe place Before using your TBP12, carefully read the applicable items of these operating instructions and the safety suggestions. 1. Obey all warnings in the TBP12 manual. 2. Do not perform service operations beyond those described in the TBP12 manual. Service is required when the apparatus has been damaged in any way, such as: 3.
Basic Operation 1. ON/OFF Switch - Slide the switch to turn the transmitter on or off. 4 BATT 3 MUTE 2. Input - Connect your instrument here. 3. Mute - Press to mute/unmute audio signal. AUDIO 1 OFF/ON 4. Battery LED - Blue LED = full, solid red LED = Low, Flashing red LED = Very Low / Change batteries. Audio LED - Green LED = Audio Signal 5. LCD Display - Whenever a button is first pushed, the LCD backlight BATT will awaken by glowing.
LCD Setup Pages Setup Page 3 - Name Select Setup Page 1 - Channel Select In order for your TBP12 to transmit properly to your receiver both devices must be set to the same channel. To change the channel your TBP12 is transmitting on, Hold SELECT for 2 seconds to enter setup page 1. Press VALUE briefly to increment from CHANNEL 1 - 12. The current channel number is displayed as 1 to 12 on the right side of the numeric display.
Battery Installation / Removal Troubleshooting Issue No sound Cause Intermittent sound or Source malfunction, Improper condistorted sound nection, Multiple transmitters are set to the same operating channel, Transmitter has gone out of range, Transmitting through metal wall, Unknown source of RF in local area Lockout Mode set to unlock allowing channels to get changed which creates momentary signal mutes in the receiver Lack of range Open the side door to access the battery compartment.