® DT50 Guitar Amplifier Pilot’s Guide Manuel de pilotage Pilotenhandbuch Pilotenhandboek Manual del Piloto 取扱説明書 40-00-0284 Pilot’s Handbook available @ www.line6.
Important Safety Instructions C AU T IO N R ISK O F E LE C TR IC SH O C K DO NOT O PE N WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE. CAUTION: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of FCC Rules.
You should read these Important Safety Instructions. Keep these instructions in a safe place • • • • • • • • • • • • • • • • • • • • • Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Front Panel Controls & Connections 1. Guitar In – Plug your guitar in here. It’s not uncommon to use HIGH input for guitars equipped with standard pickups and LOW when using guitars equipped with active electronics. Some like to use HIGH input for guitars equipped with single coil pickups and LOW when using guitars equipped with humbuckers. There’s no hard and fast rule – just plug in to the input that sounds best to you. 2. Power Switch – Connect the included power cable to your rear panel.
DESIGNED IN U.S.A. MADE IN CHINA CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN 41-00-0291 -B LO F US E MIDI LEVEL OUT CABINET-SIMULATED DIRECT OUT EFFECT LOOP RETURN SEND (POWER AMP IN) (PREAMP OUT) GND 100V - 120V = T5.0AL / 250V SLO-BLO FUSE 220V - 240V = T2.5AL / 250V SLO-BLO FUSE LIFT U.S. PATENT NO. 5,789,689 TUBE AMP DESIGN BY POWER REQUIREMENTS MAINS FUSE – CAUTION: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE REPLACE ONLY WITH SAME TYPE FUSE.
• No additional cables are required to connect a POD HD (300/400/500) to a DT50 series guitar amplifier. • Changing Tone settings (for example) on either the POD HD or DT50 immediately updates the other, with the result that both units stay perfectly in sync. • “Edit” a preset on a POD HD by simply turning knobs on the DT50 as one would any other guitar amp, then save it on the POD HD to perfectly recall every time the preset is selected.
MIDI Implementation Continous Controller (MIDI CC #) Value Function 19 0-63 = Channel A, 64-127 = Channel B Channel A/B Toggle 77 0 = Voicing I, 1 = Voicing II, 2 = Voicing III, 3 = Voicing IV Channel A Voicing (I, II, III, IV) 73 0-63 = Class A, 64-127 = Class AB Channel A Operation Class Configuration (Class A / Class AB) 75 0-63 = Triode, 64-127 = Pentode Channel A Power Tube Configuration (Pentode/Triode) 36 0-63 = Reverb Off, 64-127 = Reverb On Channel A Reverb On/Off 114 0 = Voicing