User's Manual

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

Any changes or medications not expressly approved by party responsible for

compliance could void the user’s authority to operate the equipment.

RSS-Gen & RSS-210 Statement:

"This device complies with Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils

radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)

l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit

accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en

compromettre le fonctionnement."

RSS-102 Statement:

"This equipment complies with Industry Canada radiation exposure limits set forth for

an uncontrolled environment. "

"Cet équipement est conforme à l'exposition aux rayonnements Industry Canada limites

établies pour un environnement non contrôlé. "

PAGE 1
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or medications not expressly approved by party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 2
linear motion systems Setup: Wireless remote Setup Funkfernbedienung Erstinbetriebnahme 1. Make sure that the actuator is connected to the power supply system. 2. Open the battery cap at the backside of the remote and insert the battery. If the battery is already inside, remove the PVC st ripe. 3. Plug the DIN plug into the actuator. Afterwards the MC301/MC307 will make a short tone. Isochronal press S1+S2 together( the upper two buttons) for 5 seconds on the remote handset.