Lilee Systems™ TransAir™ PTC-3000 Family User Manual July 13, 2012
Lilee Systems™ TransAir™ PTC-3000 Family User Manual Copyright and Trademark Notice This manual and all software described herein are protected by copyright: © 2011 Lilee Systems, Ltd. Lilee and TransAir are trademarks of Lilee Systems. All rights reserved. The information in this document is subject to change without prior notice in order to improve reliability, design and function and does not represent a commitment on the part of the manufacturer.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 1 BEFORE YOU BEGIN ................................................................................................................................ 1 1.1 1.2 1.3 1.4 1.5 1.6 1.7 1.8 1.9 1.10 2 INTRODUCTION ......................................................................................................................................... 9 2.1 3 FEATURES ............................................................................................
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 5 CONFIGURING THE PTC-3000 .............................................................................................................. 26 5.1 CONFIGURATION COMMANDS ...........................................................................................................................
Lilee Systems™ TransAir™ PTC-3000 Family User Manual FIGURE 3-1 – PTC-3000-1U INTERFACE PANEL CONNECTOR LOCATIONS (FRONT AND REAR) WITH SIM/USB/RESET PANEL COVER REMOVED .......................................................................................................10 FIGURE 3-2 – PTC-3004 INTERFACE PANEL CONNECTOR LOCATIONS (PTC-3006 AND PTC-3201~4 WILL HAVE SAME OR LESS PORTS AND WITH SIMILAR FUNCTIONALITIES) ............................................................................
Lilee Systems™ TransAir™ PTC-3000 Family User Manual TABLE 1-1 – PACKAGE CHECKLIST ..........................................................................................................................................7 TABLE 1-2 – OPTIONAL STARTER KIT......................................................................................................................................8 TABLE 3-1 – INTERFACE PANEL CONNECTORS .................................................................................
1 Before You Begin Carefully remove and inspect the package contents. Refer to the Package Checklist below. Please adhere to the following Safety Considerations. 1.1 RF EXPOSURE COMPLIANCE REQUIREMENTS/ EXIGENCES DE CONFORMITÉ DE L'EXPOSITION RF The PTC-3000 family must be professionally installed and must ensure a minimum separation distance listed below between the radiating structure and any person. Note that with Fixed installation with highest gain antenna of 14.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual La famille PTC-3000 doit être installé par un professionnel et doit assurer une distance minimale de séparation entre les ci-dessous la structure rayonnante et toute personne. Notez que l'installation fixe avec antenne haut gain de 14.1dBi, l'antenne du produit, sous conditions normales d'utilisation, devrait être à 2.08 m du corps de n'importe quel utilisateur pour l'installation fixe.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 1.2 Safety Considerations Please ensure the following safety precautions are adhered to at all times. Follow electrostatic precautions whenever the PTC-3000 is installed. To prevent malfunction or damage which may be caused by Electrostatic Discharge, the PTC3000 should be grounded. Before touching components or connecting/disconnecting cables, the installer should touch a metal object to dissipate body charge.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual manufacturer may void the user’s authority to operate this device. Furthermore, this device is intended to be used only when installed in accordance with the instructions outlined in this manual. Failure to comply with these instructions may void the user’s authority to operate this device.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 1.8 Antenna guidelines/ Les lignes directrices d'antenne OPERATIONAL & SAFETY NOTICES The licensee is required to comply with all limits on frequency of operation, antenna location, power, and effective antenna height. The installer must take the following into consideration: • Antennas must be installed by professional antenna installers only.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual • Les antennes, modifications à l'équipement ou des pièces jointes peut annuler toute garantie de l'équipement ou de l'autorité de transmettre. Modification pourrait endommager la radio et de violer la réglementation de la FCC ou IC. • Pour FCC CFR partie 47 95F opération, la puissance d'émission est limitée à 4.48W au port d'antenne pour station émettrice portable (CTS), et 1W au port d'antenne pour l'unité émetteur de réponse (RTU).
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 1.9 Package Checklist The TransAir PTC-3000 is shipped with the following items. Inspect the package contents to ensure all the components are included. If any of these items are missing or damaged, contact the distributor or sales representative immediately.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 1.10 Optional Starter Kit The following optional starter kit is available made to order. Item and Part Number RJ45 to DB9 cable (PTC-3001 only) 3-pin terminal block to DC adapter cable (PTC-3001 only; NOTE: Professional installer need to provide ferrite 0461164281 or solid version (from fair-rite.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 2 Introduction The Lilee Systems TransAir PTC-3000 product family includes three components: TransAir Wayside, TransAir Base Station and TransAir Locomotive radios.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 3 Interface Panel Connectors The connectors on the interface panel of the TransAir PTC-3000 are shown in the figures below.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual Figure 3-2 – PTC-3004 Interface Panel Connector Locations (PTC-3006 and PTC-3201~4 will have same or less ports and with similar functionalities) The figure below shows the location of the SIM card slot, USB Flash Drive, and Reset button on the PTC-3201~4 PTC-3004 and PTC-3006 units.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual The table below lists the connectors and type on the interface panel of the TransAir PTC-3000.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 3.3 220 MHz Antenna The TransAir PTC-3000 provides two N-Type connectors for connecting to 220 MHz antennas. The table below lists the pinouts for the 220 MHz Antenna connectors. Pin No. Description Center RF Outer GND Table 3-4 – 220 MHz Antenna Connector Pinouts When selecting cables for connecting the PTC-3000 to 220 MHz antennas, quality is critical. Poor quality cables can result in significant signal loss.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 3.6 LAN There are two RJ45 ports on the PTC-3001 and two M12 connectors on the PTC-3201~4, PTC-3004, and PTC-3006 for connecting to a local network. The following table lists the pinouts for the RJ45 ports and M12 connectors. Pin No. Description PTC-3000-1U (RJ45) 1 2 3 4 5 6 7 8 Table 3-8 3.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 3.8 RS-232/422/485 Serial There are two RJ45 ports on the PTC-3000 and two M12 connectors on the PTC4MCU/6MCU for connecting to RS-232/422/484 serial devices. See the following table for the Serial port pinout definitions for the RJ45 connector on the PTC-3000-1U and corresponding definitions on the DB9 serial port end of an M12 to DB9 cable. Pin No. (RJ45 Termination) Description Pin No.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 3.10 LED Indicators The front panel of the PTC-3000 contains several LED indicators. See the figure below for the location of each indicator. Figure 3-4 – LED Indicators The functions of each are described in the table below. LED Color State Description On Powered on. Power Green Off Powered off or no power current. On System fault has occurred. Health Green Off System is functioning normally. On 220 MHz interface is linked up.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 3.11 PTC-3000 RF (220MHz RF board) The regulatory tested PTC-3000 RF (220MHz RF board) is an integral part of the wireless communication, with 2 RF ports, PRI and SEC, digital communication protocol and control from the host board, and single power supply input.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 4 Installation 4.1 Connecting Cables Please see Chapter 3 Interface Panel Connectors for pinout details of the connectors on the PTC-3000. The following section describes how to connect cables and devices to the PTC-3000. Connect according to your configuration requirements. 4.1.1 RJ45 to DB9 Console Cable (PTC-3000-1U) Step 1: Locate the RJ45 Console connectors. The location of the RJ45 Console port connector is shown in Figure 1.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 4.1.3 RJ45 LAN Cable (PTC-30001) Step 1: Locate the RJ45 LAN connectors. The locations of the LAN connectors are shown in Figure 1. Step 2: Align the connectors. Align the RJ45 connector on the LAN cable with one of the RJ45 connectors on the PTC-3000. Step 3: Insert the LAN cable RJ45 connector. Once aligned, gently insert the LAN cable RJ45 connector into the PTC-3000 RJ45 connector. Step 4: Connect to a LAN router/switch.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 4.1.6 M12 to DB9 Serial Device Cable (PTC-3201~4, PTC-3004, and PTC-3006) Step 1: Locate the M12 serial connector. The location of the M12 serial port connector is shown above in Figure 2. Step 2: Insert the M12 to DB-9 cable. Insert the M12 end of the cable into the M12 serial connector of the PTC-3000. Step 3: Secure the M12 connector.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 4.1.9 TNC to TNC Cable for Syncing PTC-3000 Units Step 1: Locate the 1pps TNC connectors. The location of the 1pps TNC connectors is shown above in Figure 1 and Figure 2. Step 2: Insert the TNC cable. Insert one end of the TNC connector into the 1pps TNC connector of one PTC-3000. Step 3: Secure the TNC cable. Turn the locking cover of the TNC connector end of the TNC connector clockwise to secure connector on the PTC-3000.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual Figure 4-1 – SIM/USB/Reset Panel Cover 4.2.2 USB Flash Drive Removal Step 1: Grasp USB Flash Drive from the top and bottom of the flat surface as shown in the figure below (yellow arrows). Step 2: Pull outward to remove (green arrow).
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 4.2.3 Step 1: USB Flash Drive Installation Locate USB port (see figure below). Figure 4-3 – USB Port Location (1U unit shown) Step 2: Insert USB Flash Drive into USB port as shown in the figure below.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 4.2.4 Replace SIM/USB/Reset Panel Cover Step 1: Replace Cover. Step 2: Refasten screws. Using a screwdriver, fasten the screws by turning clockwise. Figure 4-5 – Replace SIM/USB/Reset Panel Cover 4.3 SIM Card Installation Step 1: Remove SIM/USB/Reset Panel Cover as in 4.2.1 Remove SIM/USB/Reset Panel Cover. Step 2: Open SIM card slot protective cover. Slide SIM card slot protective cover down as show below (yellow arrow).
Lilee Systems™ TransAir™ PTC-3000 Family User Manual Step 3: Insert SIM card. Slide SIM card into the protective cover with the card’s metallic contact facing toward the slot. Step 4: Close SIM card slot protective cover. Step 5: Lock SIM card slot protective cover. Slide SIM card slot upward. Step 6: Replace SIM/USB/Reset Panel Cover as in 4.2.4 Replace SIM/USB/Reset Panel Cover.
Lilee Systems™ TransAir™ PTC-3000 Family User Manual 5 Configuring the PTC-3000 5.1 Configuration Commands To begin configuring the PTC-3000, use a terminal emulation program like HyperTerminal, PuTTy, or Tera Term to connect to the PTC-3000 and enter configuration commands.
Lilee Systems, Ltd 2905 Stender Way, Suite 78 Santa Clara, CA 95054 Tel: 408.988.8672 www.lileesystems.com information@lileesystems.
