WBD-500 Quick Installation Guide Revision 1.0 August 5, 2008 Copyright © 2008 LigoWave www.ligowave.
Copyright © 2008 LigoWave This user’s guide and the software described in it are copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of LigoWave. Notice LigoWave reserves the right to change specifications without prior notice.
FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Quick Installation Guide Contents FCC Antenna Compliance The WBD-500 has been tested and certified with the following antennas: 2.4GHz Type Model Gain (dBi) Power EIRP Operation Mode Grid HyperGain HG2424G 24 24 48 PTP Panel ARC-IA2419B02 19 25 44 PTP Omni Hwayaotek OA-2450-12 12 24 36 PTMP Any antenna of same make and lower gain than those listed above may be used in compliance with certification. The maximum FCC EIRP limits are listed above with given antennas.
Quick Installation Guide Contents Contents Copyright ............................................................................................................................................. 2 Notice .................................................................................................................................................. 2 Trademarks .........................................................................................................................................
Quick Installation Guide About This Guide About This Guide Purpose The purpose of this guide is to provide a quick and easy explanation of getting started with the WBD500. This is only a starter guide and full documentation may be found at our online wiki: http://www.ligowave.com/wiki Definitions, Acronyms and Abbreviations The following typographic conventions and symbols are used throughout this document: Additional information that may be helpful but which is not required.
Quick Installation Guide Installation Installation This chapter provides installation instructions for the hardware and software components of the WBD500.
Quick Installation Guide Installation Connectors The WBD-500 has several connectors on the bottom and side panels.
Quick Installation Guide Access the WBD-500 Access the WBD-500 The first connection to the WBD-500 can be made using a standard Ethernet cable connected directly to your PC. See next sections for the instructions on how to access the WBD-500 management interfaces. Connection via WEB browser The default IP address of the WBD-500 is 192.168.2.66 with a subnet mask of 255.255.255.0. Step 1 Configure your PC with a static IP address on the 192.168.2.0 subnet with mask 255.255.255.0.
Quick Installation Guide Access the WBD-500 Resetting to Factory Defaults LigoWave products have the capability of being reset to defaults by pinging the device with a certain packet size when the radio is booting. During the startup of the device, when the drivers of the ethernet interfaces are loaded, the discovery daemon is started. The daemon suspends startup process for 3 seconds and waits for ICMP "echo request" packet of length 369 bytes.