LigoPTP 3-N Quick Installation Guide Revision 1.1 June 1, 2009 Copyright © 2008 LigoWave www.ligowave.
Copyright © 2008 LigoWave This user’s guide and the software described in it are copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of LigoWave. Notice LigoWave reserves the right to change specifications without prior notice.
FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
FCC Antenna Compliance The LigoPTP 3-N - R2 radio module is compliant with any antenna of lesser or equal gain as specified in the chart below given channel bandwidth and radio conducted power. A higher gain antenna may be used if radio conducted power is lowered. For every 1dBm that the radio’s conducted power is lowered, an increase of 1dB may be added to the allowed antenna gain assuming the total EIRP does not exceed the Limit in the following table.
Contents Copyright............................................................................................................................................2 Notice.................................................................................................................................................2 Trademarks........................................................................................................................................2 FCC Warning .......................................
About This Guide Purpose The purpose of this guide is to provide a quick and easy explanation of getting started with the LigoPTP 3-N. This is only a starter guide and full documentation may be found at our online wiki: http://www.ligowave.com/wiki Definitions, Acronyms and Abbreviations The following typographic conventions and symbols are used throughout this document: Additional information that may be helpful but which is not required. Important information that should be observed.
LigoWave Page 7
Installation This chapter provides installation instructions for the hardware and software components of the LigoPTP 3-N.
Connectors The LigoPTP 3-N has several connectors on the bottom and side panels.
Mounting the LigoPTP 3-N LigoWave Page 10
Access the LigoPTP 3-N The first connection to the LigoPTP 3-N can be made using a standard Ethernet cable connected directly to your PC. See next sections for the instructions on how to access the LigoPTP 3-N management interfaces. Connection via WEB browser The default IP address of the LigoPTP 3-N is 192.168.2.66 with a subnet mask of 255.255.255.0. Step 1 Configure your PC with a static IP address on the 192.168.2.0 subnet with mask 255.255.255.0.
Resetting to Factory Defaults LigoWave products have the capability of being reset to defaults by pinging the device with a certain packet size when the radio is booting. During the startup of the device, when the drivers of the ethernet interfaces are loaded, the discovery daemon is started. The daemon suspends startup process for 3 seconds and waits for ICMP "echo request" packet of length 369 bytes. If the packet received, the discoveryd resets the device to default configuration.
