FWBD01 Quick Installation Guide Revision 1.3 February 10, 2011 Copyright © 2011 LigoWave www.ligowave.
Copyright © 2010 LigoW ave This user’s guide and the software described in it are copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of LigoWave. Notice LigoW ave reserves the right to change specifications without prior notice.
FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Antenna Compliance The FWBD01 radio module has been tested and certified with the following antennas: Dish (32.5dBi) – Laird HDDA5W-32-DP Panel (23dBi) – Arc Wireless ARC-ID5823B88 Any antenna of same make and lower gain than those listed above may be used in compliance with certification. CE Mark Warning This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
Quick Installation Guide About This Guide About This Guide Purpose The purpose of this guide is to provide a quick and easy explanation of getting started with the FWBD01. This is only a starter guide and full documentation may be found at our online wiki: http://www.ligowave.com/wiki Definitions, Acronyms and Abbreviations The following typographic conventions and symbols are used throughout this document: Additional information that may be helpful but which is not required.
Quick Installation Guide Introduction Hardware Introduction General Overview The label of the FWBD01 contains: Model name. The official model name is FWBD01. FCC ID. The FCC ID is V2V-FWBD01 IC ID.
Quick Installation Guide Access the FWBD01 Access the FWBD01 The first connection to the FWBD01 can be made using a standard Ethernet cable connected directly to your PC. See next sections for the instructions on how to access the FWB01 management interfaces. Connection via WEB browser The default IP address of the FWBD01 is 192.168.2.66 with a subnet mask of 255.255.255.0. Step 1 Configure your PC with a static IP address on the 192.168.2.0 subnet with mask 255.255.255.0.
Quick Installation Guide Access the FWBD01 Resetting to Factory Defaults LigoW ave products have the capability of being reset to defaults by pinging the device with a certain packet size when the radio is booting. During the startup of the device, when the drivers of the ethernet interfaces are loaded, the discovery daemon is started. The daemon suspends startup process for 3 seconds and waits for ICMP "echo request" packet of length 369 bytes.