Package content Assembling Mounting LigoDLB Propeller 2 LigoDLB Propeller 5 RSSI LEDs installation LAN LED Operating modes Azimuth beamwidth Azimuth beamwidth 15o 60o Power LED Reset LAN + PoE CPE mode x4 screws and plastic inserts x2 plastic clamps AP mode PoE connection Insert brancket Power cord is region dependent Wall mounting Power cord PoE power adapter Wall/pole mount Data In Pole mounting LAN + PoE
Default login settings IP address: DHCP client (fallback IP 192.168.2.66) Login: Login: admin Pass: admin01 Important information Copyright © 2015 LigoWave This guide and the software described in it are copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of LigoWave.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Warnings: This device complies with Industry Canada’s licence-exempt RSSs Operation is subject to the following two conditions: (1) This device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.