ROUND-1SP Wireless motion sensor, rolling code 433.92 MHz, recessed with built-in light sensor. CR2450 battery. www .lightengineering.
INDEX 1 - PRODUCT FEATURES 1.1 - TECHNICAL DATA 1.2 - BATTERY CHANGE 2 - PREPARATION 2.1 - SENSOR DIMENSIONS AND WORK 2.2 - POSITION OF REED CONTACT FOR MAGNET 2.3 - MAGNET INSTALLATION 3 - USE OF THE SENSOR 4 - RADIO PROGRAMMING 5 - SENSOR SETTING 2 www.lightengineering.
1 - PRODUCT FEATURES 1.1 TECHNICAL DATA Power supply Battery CR 2450 Battery life About 2 years Code Rolling code Radio frequency 433,92 MHz ISM Range 10m Infrared sensor Joint spring Button Extraction side Battery Led 1.2 BATTERY CHANGE + Battery type: CR2450 www.lightengineering.
2 - PREPARATION 2.1 CUTTING Diameter: 38mm Diameter: 34,5mm Min. 12,5mm Diameter: 35mm 3 - USE OF THE SENSOR There is two selectionable functioning mode: AUTOMATIC: when the sensor is turn on, the light turn on automatically while it detects a movement and turn the light off after a pre-set time. It’s possible to set a brightness threshold to avoid the turn on of the light if the environmental light is enought.
4 - SENSOR PROGRAMMING This procedure is used to programme a channel in order to then associate it with a compatible receiver. Access to the receiver is required to carry out the following procedure. STEP1 Activate the receiver on which you want to use the transmitter in “multifunctional remote control radio programming” (see receiver manual).
5 - SENSOR SETTING The sensor is supplied with pre-set parameters: DETECTION AREA= max ; BRIGHTNESS THRESHOLD= off ; TIMED ON= 5 minutes.
FCC NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
07/2019_Rev 1.1 LIGHT ENGINEERING + DESIGN SRL Via Spagna, 6 - 35010 Vigonza (PD) Ph. +39 049 0980809 Email: info@lightengineering.net Web: www.lightengineering.