Troubleshooting Guide

MODEL: 2MNQI0728
PLEASE MAKE SURE TO USE A WALL ADAPTER
OR USB PORT THAT IS 2.4A
QC3.0 or PD3.0 CHARGERS WILL ENABLE FAST CHARGE
FUNCTION.
NORMAL & FAST
WIRELESS CHARGING
GET TO KNOW
YOUR CHARGER
TROUBLESHOOTING
•SINGLE-COIL QI WIRELESS CHARGER
•INDUCTIVE CHARGING
•CHARGING INDICATOR LED
•DESIGNED FOR QI COMPLIANCE
INCORRECT
PLACEMENT
CORRECT
PLACEMENT
FAST
CHARGE
LED
INDICATOR
QI™
ENABLED
ANTI-SLIP
SURFACE
FOR iPHONE
WIRELESS CHARGING
!
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
CAUTION:
approved by the party responsible for compliance could
void the user's authority to operate this device.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by on
e or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
for help.
IF YOU HAVE PROBLEMS WITH WIRELESS CHARGING
MAKE SURE YOUR PHONE IS CENTERED ON CHARGER.
QI™ WIRELESS
COMPATIBLE
SMARTPHONE
SURFACE
FOR WIRELESS
CHARGING
BACK
FRONT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
FCC Radiation Exposure Statement:
® ® ® ® ® ®
® ® ® ®
INPUT: OUTPUT:5V2A,12V1.25A
FOR MAX CHARGING SPEED USE
WILL ONLY CHARGE THROUGH CASES 5MM THICK OR LESS
DNA WIRELESS CHARGER
IC Warning
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioé
lectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement
RF warning for Mobile device:
This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm between
the radiator & your body.