User's Manual

ManualsBrandsLifeShield ManualsElectronicsWireless Security System Keypad

Table Of Contents

Console Installation Instructions

Model: KPC1000 Console Kit

InGrid Console Kit Contents

KPC1000 InGrid Console

PSC0101 Power Supply

IG180 Ni-MH Rechargeable Battery Pack

Phone Cord; Long

Phone Cord; Short

Table Stand

Wall Plate & 2 Screws

Determine the Location

The Console may be used on a table top or

mounted to the wall on a telephone wall

plate near a wall outlet.

Install the Console

Install Battery Pack – The battery pack is

shipped packed inside the Console, but it is

not connected.

Open the battery compartment and remove

battery

a. Insert the battery plug into the two-pin

jack, and insert the battery.

b. Replace the battery cover.

Install the Console

Table Top Use – If installing the Console on

a table top, perform the following steps.

a. Connect power supply to the back of

the Console.

b. Connect the long phone cable to the

back of the Console.

c. Route the wires up through the

channel toward the top of the Console.

d. Snap the table stand provided in the

kit to the bottom of the Console.

e. Connect the free end of the

telephone cable to the wall phone jack.

f. Plug the power supply into nearby

electrical wall outlet that is not controlled

by a switch.

Wall Mounting – If mounting the Console to

a wall, perform the following steps.

a. Screw the Console mounting plate

to the back of the Console.

b. Connect power supply to the bottom

of the Console.

c. Connect phone cable to the bottom

of the Console.

d. Route the wires through the channel

of the Console mounting plate.

e. Connect the phone cord to the wall

phone jack.

f. Slide the Console with mounting

plate onto the phone wall plate.

g. Plug the power supply into nearby

electrical wall outlet that is not

controlled by a switch.

CAUTION

RISK OF EXPLOSION

IF BATTERY IS

REPLACED BY AN

INCORRECT TYPE.

DISPOSE OF USED

BATTERIES

ACCORDING TO THE

INSTRUCTIONS.

Summary of content (4 pages)

PAGE 1
Console Installation Instructions Model: KPC1000 Console Kit InGrid Console Kit Contents c. Route the wires up through the channel toward the top of the Console. d. Snap the table stand provided in the kit to the bottom of the Console.
PAGE 2
Note: o o o Use only InGrid IG180 rechargeable battery packs supplied with your various Home Protection components. Replacement battery packs are also available through the InGrid’s customer service at 1-877-INGRID7 or on-line at www.InGridHome.comUse only the supplied AC power adapter. Do not use any other adapter. Place the power cord so that it does not create a trip hazard or where it could become pinched and create an electrical new Handset or Console you are looking to add. 2.
PAGE 3
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: o o o Reorient or relocate the receiving antenna Reorient or relocate and increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
PAGE 4
Notice: The Ringer Equivalence Number (REN) for this terminal equipment is marked on the equipment itself. The REN assigned to each terminal equipment provides and indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices not exceed five.