Installation & Operation Guide

13.
BCone | Installation & Operation Guide
Rev B | Doc P/N: BC-00-70-002
Make Your Pool Safer
Smart & Simpool
SETTING UP THE POOL UNIT
Perform the following steps to set up the Pool Unit:
Use one of the following
options to attach the Pool
Unit to the side of the
pool:
A
Connect the attachment
string between the cone
hook and the Pool Unit
hook.
B
Place the Pool Unit in the
water.
C
NOTE: Choose the Pool Unit location
based on the Recommendations for
Pool Unit Installation.
Verify that the surface is completely dry.
Expose the double-sided sticker and
attach it to the side of the pool by
applying pressure to remove all air
bubbles.
A1
Attach the attachment cone to the side of
the pool using two screws (not provided).
A2
Verify that the surface is completely dry.
Use the suction cup to attach the Pool
Unit to the side of the pool.
A3
NOTE: The Pool Unit is delivered
operational and already paired with
the Home Unit. There is no need to
turn on the Pool Unit power.
Connect the attachment string to the Pool
Unit using the attachment hook, and the
other end to any anchor point on the side
of the pool.
A4
HOME
SAFETY
INTRODUCTION
OPERATION
SERVICE
MULTI BCONE
GETTING STARTED