Users Manual Part 2

ORIGINAL EQUIPMENT MANUFACTURER (OEM) NOTES
The OEM must certify the final end product to comply with unintentional radiators (FCC Sections
15.107 and 15.109) before declaring compliance of the final product to Part 15 of the FCC rules and
regulations. Integration into devices that are directly or indirectly connected to AC lines must add
with Class II Permissive Change.
The OEM must comply with the FCC labeling requirements. If the module’s label is not visible
when installed, then an additional permanent label must be applied on the outside of the finished
product which states: “Contains transmitter module FCC ID: N8NLSD4BT‐S95. Additionally, the
following statement should be included on the label and in the final product’s user manual: “This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interferences, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.”
The module is allowed to be installed in mobile and portable applications
A module or modules can only be used without additional authorizations if they have been tested
and granted under the same intended end‐use operational conditions, including simultaneous
transmission operations. When they have not been tested and granted in this manner, additional
te
sting and/or FCC application filing may be required. The most straightforward approach to address
additional testing conditions is to have the grantee responsible for the certification of at least one of
the modules submit a permissive change application. When having a module grantee file a
permissive change is not practical or feasible, the following guidance provides some additional
options for host manufacturers. Integrations using modules where additional testing and/or FCC
application filing(s) may be required are: (A) a module used in devices requiring additional RF
exposure compliance information (e.g., MPE evaluation or SAR testing); (B) limited and/or split
modules not meeting all of the module requirements; and (C) simultaneous transmissions for
independent collocated transmitters not previously granted together.
This Module is full modular approval, it is limited to OEM installation ONLY.
Integration into devices that are directly or indirectly connected to AC lines must add with Class II
Permissive Change. (OEM) Integrator has to assure compliance of the entire end product include
the integrated Module. Additional measurements (15B) and/or equipment authorizations (e.g.
Verification) may need to be addressed depending on co-location or simultaneous transmission
issues if applicable. (OEM) Integrator is reminded to assure that these installation instructions will
not be made available to the end user