User's Manual

1. The Nano Receiver is stored inside the mouse, in the battery compartment.
To remove the receiver, open your battery compartment and remove the receiver
as per step 1.
2. Once you have finished using the mouse, remove the receiver from your USB port
and replace within the mouse housing as per step 2.
1
2
Remove the Receiver Store the Receiver
Storing the Nano Receiver
Instruction Manual
RF2.4GHz Optical Mouse
Please read these instructions carefully before
first use and retain them for future reference.
Step 1. Open the back cover.
Step 3. Replace back cover.
Installing Batteries
The RF2.4GHz optical mouse uses two AAA batteries .
Installing Batteries:
Step 2. Insert the batteries as showed below .
Connecting the Receiver
USB Port
1. Connect the nano receiver ONLY to a USB port on your computer.
Nano receiver
Dimension:L124XW71.7XH61.5MM
2.4GHz wireless optical mouse with 6 keys
Ergonomic design，suitable for both hands
Resolution:800/1600/240ODPI switching
High precision optical engine
Self-storing nano Receiver,easy to take
2 .4GHz RF transmission，up to 10m
USB interface plug&play
Compatible with computers of various systems and brands
Model:SFMT 2.4 A1
Warning: changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruct
ions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit differe
nt from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)this device may not cause harmful interference,
(2)this device must accept any interference received, including
interference that may cause undesired operation.
Model:SFMT 2.4 A1