User Manual Wireless 2.4G Optical Mouse Caution: To use this device properly, please read the user’s guide before installation Battery Installation Wireless mouse use 1*AA or 2*AA alkaline battery.
Battery Installation Procedure of Mouse Step 1: Open the battery cover. Step 2: Insert one AA or Two AA batteries into the battery compartment as picture below. Step 3: Close the battery cover. USB Wireless Receiver Connection Plug in the receiver unit into an USB port of connector. DPI Shift Function This 6 button optical mouse is provided 1000/1200/1600 DPI switch.
Obtain the receiver from Mouse 1. When you want to use the mouse, please take out the receiver from the bottom of the mouse and insert into your laptop (step 1); 2. When you are not working or travelling, you can restore the receiver into the bottom of the mouse (step 2).
Energy Saving Mode The mouse goes into power saving mode when: Nano-receiver is not plugged into PC/notebook, Nano-receiver is switched off when plugged into the PC/notebook or when the mouse is no longer in use after 30 minutes. With the intelligent power saving mode to conserve power, the mouse switches to sleep mode after 8 mins.
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. However, there is no guarantee that interference will not occur in a particular installation.
