TEMPERATURE STATION / ESTACIÓN METEOROLÓGICA Distributed by / Distribuido por: Lidl US LLC., Arlington, VA 22202 Model No. / Modelo Núm.: HG02132A-US / HG02132B-US (HG02132A-US-RX & HG02132A-US-TX / HG02132B-US-RX & HG02132B-US-TX) Version / Versión: 03 / 2017 TEMPERATURE STATION Operation and Safety Notes ESTACIÓN METEOROLÓGICA Instrucciones de utilización y de seguridad Made in / Hecho en: China Last Information Update · Estado de las informaciones: 02 / 2017 · Ident.-No.
US-EN Operation and Safety Notes US-ES Instrucciones de utilización y de seguridad 284995_aur_Temperaturstation_cover_US.indd 3-4 Page 3 Página 21.03.
Description of signal words..................Page 4 Customer service..........................................Page 4 Introduction......................................................Page 5 Proper use...........................................................Page 5 Description of parts and features.......................Page 5 Technical data.....................................................Page 9 Scope of delivery................................................Page 10 Important safety notes........
DESCRIPTION OF SIGNAL WORDS WARNING indicates a hazardous situation that, if not avoided, could result in death or serious injury. CAUTION indicates a hazardous situation that, if not avoided, could result in minor or moderate injury. NOTICE indicates information considered important, but not hazard related (e.g. messages related to property damage). CUSTOMER SERVICE Call customer service at 1 (844) 543-5872 Visit the Website Customer Service Platform at www.lidl.
Temperature station Introduction Congratulations on your purchase. You have selected a quality product. The instructions for use are a part of the product. They contain important information about the safety, use and disposal of the appliance. Before using the product, please learn about all the safety information and usage instructions. Only use the product as described and for the specified applications. If you lend the product to someone else, please also give all the instructions.
5 Seconds display 6 Day of the week display 7 MAX- / MIN display (outdoor temperature) 8 Temperature trend (outdoor temperature) 9 Outdoor temperature 10 Radio signal symbol 11 symbol (outdoor sensor) 12 MAX- / MIN display for indoor 13 14 15 16 17 18 temperature Indoor temperature symbol (temperature station) Temperature trend (indoor temperature) / symbol (Alarm 1 / Alarm 2) Time 2nd time zone (ZONE) 1 18 4 17 16 15 5 6 7 8 9 14 13 6 2 3 12 11 10 US-EN 4995_aur_Temperaturstation_content_US.
Temperature station 19 CLOCK button 20 ALARM button 21 ZZ / REGISTER button (snooze function / REGISTER) 22 Hanging slot 23 SELECT button 24 SET / RESET button 25 Battery compartment 26 Stand 27 Screw (D 0.1 in / 3 mm) 28 Dowel (D 0.3 in / 7.7 mm) 19 20 21 22 23 24 25 26 28 4995_aur_Temperaturstation_content_US.indd 7 27 US-EN 7 21.03.
Outdoor sensor 29 Control LED 29 30 31 32 33 Hanging slot Battery compartment Screw (D 0.1 in / 3 mm) Dowel (D 0.3 in / 7.7 mm) 30 31 8 32 33 US-EN 4995_aur_Temperaturstation_content_US.indd 8 21.03.
Technical data Temperature station: Model No.: HG02132A-US-RX / HG02132B-US-RX FCCID: 2AJ9O-HG2132RX Temperature measurement range: 0 °C – + 50 °C +32 °F – +122 °F Note: If the temperature is ≤ 0 °C (32 °F), the LC display shows “LL.L”. If the temperature is ≥ 50 °C (122 °F), the LC display shows “HH.H”. Temperature interval: 0.1 °C / 0.1 °F Radio signal: WWVB Batteries: 2 x AA 1.5 V (direct current) (pre-installed) Outdoor sensor: Model No.
Degree of protection: I PX4 (Splash-proof) / suitable for wet locations Scope of delivery 1 Temperature station 1 Outdoor sensor 4 Batteries AA, 1.5 V (pre-installed) 2 Screws (D 0.1 in / 3 mm) 2 Dowels (D 0.3 in / 7.7 mm) 1 Drill template 1 Operating instructions I MPORTANT SAFETY NOTES READ ALL INSTRUCTIONS. KEEP FOR FUTURE REFERENCE. INCLUDE ALL DOCUMENTATION WHEN PASSING THIS PRODUCT ON TO OTHERS.
This product can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved. Children shall not play with the product. Cleaning and user maintenance shall not be made by children without supervision.
encouraged to try and correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the product and receiver. • Connect the product into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio / TV technician for help. • The RF Exposure Compliance distance is 0.78 in / 20 mm. Do not expose the product to an extremely high electromagnetic field.
ANGER TO LIFE! Keep batteries / D rechargeable batteries out of reach of children. If accidentally swallowed seek immediate medical attention. DANGER OF EXPLOSION! Never recharge disposable batteries. Do not short-circuit batteries / rechargeable batteries and / or open them. Overheating, fire or bursting can be the result. Never throw batteries / rechargeable batteries into fire or water. Do not exert mechanical loads to batteries / rechargeable batteries.
the skin. Wear suitable protective gloves at all times if such an event occurs. In the event of a leakage of batteries / rechargeable batteries, immediately remove it from the product to prevent damage. Only use the same type of batteries / rechargeable batteries. Do not mix used and new batteries / rechargeable batteries. Remove the batteries / rechargeable batteries if the product will not be used for a longer period.
Before initial use Activate the batteries first inside the outdoor sensor, then inside the temperature station. Note: Before initial use, remove the protective film from the device display. General information When choosing where to position the devices, make sure that they are not exposed to direct sunlight, vibrations, dust, heat, cold or moisture. Do not place the devices near to heat sources, e.g. radiators, as this may result in damage to the devices.
Remove the battery safety strip. The outdoor sensor is now ready for use and the control LED 29 illuminates briefly. Close the battery compartment cover. If this does not work, carry out a restart of the temperature station if necessary. To do this, press and keep pressed the ZZ / REGISTER button 21 (restart the outdoor sensor only). Preparing the temperature station for use Open the battery compartment 25 on the back of the temperature station. Remove the battery safety strip.
After successful reception of the outdoor sensor signal or after 3 minutes, the temperature station starts with the reception of the radio time signal. This process can take up to 5 minutes and is indicated in the LC display by the flashing WWVB symbol 2 . After successful reception of the WWVB radio signal, the WWVB symbol 2 is displayed continuously in the LC display. Note: Do not move the temperature station while it is receiving the signal. Otherwise this could interfere with reception.
DAMAGE! Read the operating and safety instructions for your drill carefully. DANGER TO LIFE! Take care that you do not hit electricity, gas or water lines when you drill into the wall. If necessary, check with a pipe and cable detector before drilling. Temperature station Note: Before mounting the temperature station, please remove the stand 26 by simply pulling it off. Mark the position of the hole (D 0.3 in / 7.7 mm) on the wall.
Outdoor sensor Mark the position of the hole (D 0.3 in / 7.7 mm) on the wall. Note: Use the included drilling template intended for marking the drill holes. Drill the hole with an electric drill. Insert the dowel 33 into the drilled hole. Using a crosshead screwdriver, screw the screw 32 into the dowel. Hang the outdoor sensor by placing the hanger 30 on the screw. 0.3in / 8mm 0.
1. Press and hold down the CLOCK button 19 for about 3 seconds. 2. Press the SET / RESET button 24 to switch between the 12- and 24-hour clock display modes. 3. Press the CLOCK button to confirm your settings. The language option flashes. Tip: If you press and hold down the SET / RESET button, you accelerate the process and reach the desired value more quickly. This quicker method can also be used for making the following settings.
The product is now still controlled by WWVB but shows the time as one hour ahead of PST. 7. Press the CLOCK button to confirm your settings. The hour display flashes. 8. Press the SET / RESET button to set the desired value. 9. Press the CLOCK button to confirm your settings. 10. Repeat steps 6 and 7 to set the values for, minutes, seconds 5 , year and date 4 (day / month). Note: The seconds display can only be reset to 00. 11. Press the SET / RESET button to set the DST function (ON/OFF). 12.
Note: If an alarm time has been set before, then that previously set alarm time appears in the LC display. If not, then the display shows 0:00 or AM 12:00. 2. The hour display flashes. Press the SET / RESET button 24 to set the desired value. 3. Press the ALARM button to confirm your settings. The minute display flashes. 4. Press the SET / RESET button to set the desired value. 5. Press the ALARM button to confirm your settings. 6. Repeat steps 2 to 5 to set the time for Alarm 2.
ceases automatically after a period of 2 minutes. Press the SELECT 23 / SET / RESET 24 / ALARM 20 / CLOCK button 19 to switch off the alarm signal before it switches off automatically. Note: The alarm signal sounds every day at the set time. Press the SET / RESET button three times to deactivate Alarm 1. Press the SET / RESET button twice to deactivate Alarm 2. Press the SET / RESET button once to deactivate Alarm 1 and Alarm 2.
Press the SET / RESET button 24 to switch between the °C (Celsius) and °F (Fahrenheit) temperature scales. Press the SELECT button to confirm your settings. Calling up the minimum / maximum values The temperature station stores the maximum and minimum values of the outdoor sensor and of the temperature station itself. Press the SELECT button 23 to display the maximum values of the indoor and outdoor temperature.
Battery state display 11 and 14 symbols appear in the The temperature station’s LC display if the batteries in the outdoor sensor or the temperature station are weak. Replacing the batteries Open the battery compartment 25 or 31 . Remove the exhausted batteries. Insert two new 1.5 V (direct current) batteries (AA) into the battery compartments. Note: Make sure you fit the batteries the right way round (polarity). This is shown in the battery compartments.
30 31 32 33 Close the battery compartments. Troubleshooting Note: This product has delicate electronic components. This means that if it is placed near an object that transmits radio signals, it could cause interference. If the display indicates a problem, move such objects away from the temperature station / outdoor sensor or remove the batteries for a short while from the temperature station / outdoor sensor and then replace them.
between the outdoor sensor and the temperature station. A “visual contact” between outdoor sensor and temperature station often improves the transmission. Cold (outdoor temperatures below 32°F / 0 °C) can reduce the battery power of the outdoor sensor and thereby negatively impair the radio transmission. Another factor that may cause harmful interference, are dead or weak batteries in the outdoor sensor. Replace them by new ones.
Disposal ispose of the packaging through D your local recycling facilities and in compliance with all federal, state and local regulations. b a P lease note the package markings regarding waste separation, indicated by abbreviations (a) and numbers (b), meaning: 1–7: plastics / 20–22: paper and cardboard / 80–98: composite materials. ontact your local waste manageC ment authority for additional information on how to dispose of the used product.
symbols of heavy metals are: Cd = cadmium, Hg = mercury, Pb = lead. Used batteries should therefore be disposed of through a local collection point. Warranty What does this warranty cover? The warranty covers: · Damage, breakage or inoperability due to defect. · Damage not accounted for by normal wear and tear or following the safety and maintenance instructions provided in the user manual.
What is the period of coverage and warranty resolution? The warranty is for 3 years from the date of purchase. At our discretion, product will either be refunded or replaced. What will we not do? We will not: · Start a new warranty period upon product exchange; · We will not repair product. How to process the warranty? We recommend first either: · Call customer service at 1 (844) 543-5872 · Visit the Website Customer Service Platform at www.lidl.
How does state law relate to this warranty? Any State Laws that contradict or modify the warranty listed here to the consumer’s benefit will be followed. 4995_aur_Temperaturstation_content_US.indd 31 US-EN 31 21.03.
