Module : LSN8001 FCC Qualification Application to MOST by Li Seng Technology Ltd. Rev 1.
Aims & Content Content : User Manual / User Guide FCC Statement Label of End Product User Manual of End Product Overiew Functional Block Diagram Technical Description Circuit Schematics PCB Layout & Component Layouts Part List
User Manual / User Guide (1/4) Parts Description & Before Installation : ! : Antenna Protection Cap : Remove before Test ! : Side Switch Setting > RS232 ON > S8 VBUS > S9 OFF > Power Source (Banana Plug) : 4.
User Manual / User Guide (2/4) Installation : Finished Assembly 1 1) Place the “Adaptor Board nRF2735” on “Mother Board nRF 6310” 2 2) Place the “Li Seng Bluetooth BLE Module LSN8001” on “Adaptor Board nRF2735” Remove “Antenna Protection Cap” and Connect to Testing Equipment 3 3) Connect “Tx/Rx cable” on “Li Seng Bluetooth BLE Module LSN8001” 4 4) Connect “Tx/Rx cable” on “Mother Board nRF6310”
User Manual / User Guide (3/4) Installation : 5 5) Connect Power Source by “Banana Plug” 4.
User Manual / User Guide (4/4) Direct Test Mode : The DTM RS232 interface : Baud Rate : 192000 Number of data bits : 8 No Parity 1 Stop bit No flow control (meaning no RTS/CTS)
FCC statement : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Label Of The End Product : The final end product must be labeled in a visible area with the following " Contains TX FCC ID: RR3-LSN8001 ". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement has to also be available on the label: This device complies with Part 15 of FCC rules.
Overview LSN8001 Module Apply to Bluetooth Low Energy (4.0) as Bluetooth Smart.
Electrical Data Reference of LSN8001 Module LSN8001 Module Supply Power : 1.9V to 3.
Technical Description Module Dimension : 33 x 23 x 3 (15.
PCB & Components Layout Front Rear
Part List Bill of material PCB: Version: LSN8001 1.0 Designator C1, C2, C13, C14 C3 C4 C5 C6 Value 15pF 2.2nF NA 1.8pF 1.2pF 0402s 0402s 0402s 0402s 0402s Description Capacitor Capacitor Capacitor Capacitor Capacitor C7, C9 C8 C10, C12 C11 C15 L1 L2 L3 1.0µF 1.0nF 100nF 33nF 1.5pF 8.2nH 5.6nH 3.9nH 0603s 0402s 0402s 0402s 0402s 0402s 0402s 0402s Capacitor Capacitor Capacitor Capacitor Capacitor Inductor Inductor Inductor L4 L5 10µH 15nH 0603s 0402s P1 P2 R1 22k U1 nRF8001 X1 16MHz X2 32.
Thank You ~! Further contact : Danny Tsang danny@liseng.com.