User's Manual

ManualsBrandsLG Innotek ManualsElectronicsElectronic Shelf Label

Confidential

LG Innotek

 Remote control device provides customer with several functions as below

 Waking Tag up from sleep mode

 Updating new purchase image on Tag

 Deleting purchase image on Tag

 Returning a Tag to be factory settings

1. Overview

 Remo-con description

 Release : Deleting Purchase Information on Tag

 Keep Alive : Waking Tag up from sleep mode

 Reset : Returning a Tag to be factory settings

 Registration : Updating New Purchase Information on Tag

 LED : One of any buttons is pushed, red led turns on.

After sending some data to a Tag, red led will turn off.

Profile Hook

Battery Cover Display Area

Summary of content (7 pages)

PAGE 1
Confidential 1. Overview  LG Innotek Remote control device provides customer with several functions as below  Waking Tag up from sleep mode  Updating new purchase image on Tag  Deleting purchase image on Tag  Returning a Tag to be factory settings Display Area Profile Hook Battery Cover  Remo-con description  LED : One of any buttons is pushed, red led turns on. After sending some data to a Tag, red led will turn off.
PAGE 2
. Updating new purchase image on Tag Confidential LG Innotek ☜ To change purchase information on Tag, perform the following steps : 1. Put remote controller near center of Tag’s display 2. Press and hold ‘Registration’ button on remote controller until Red LED off (about 0.5 seconds) 3. When Tag is successfully received ‘Registration’ data from remote controller, Tag’s display will be changed to “Connected” for a few minutes.
PAGE 3
. Deleting purchase information on Tag Confidential LG Innotek ☜ To release(delete) purchase information on Tag, perform the following steps : 1. Put remote controller near center of Tag display 2. Press and hold ‘Release’ button until red LED off (about 0.5 seconds) 3. If Tag was received ‘Reset’ command from remote controller, Tag will delete purchase information and Tag’s display will be changed to “Ready” 4. After step.
PAGE 4
Confidential 4. Waking Tag up LG Innotek Case 2 ☜ Case 3 To wake Tag up from sleep mode, perform the following steps : 1. Put remote controller near center of Tag display 2. Press and hold ‘Keep Alive’ button until Red LED off (about 0.5 seconds) 3. Tag will wake up and goes to next step.
PAGE 5
. Returning a Tag to be factory settings Confidential LG Innotek ☜ To make a Tag to be factory reset status, perform the following steps : 1. Put remote controller near center of Tag display 2. Press and hold ‘Reset’ button until Red LED off (about 0.5 seconds) 3. If Tag was received ‘Reset’ command from remote controller, Tag goes back to factory settings and Tag’s display will be changed to “Ready” 4. After step.
PAGE 6
Confidential 6. Tag status LG Innotek Deep Sleep Mode Connected with Gateway Disconnected with Gateway Image download Failure(“Busy”) Battery discharge (The battery needs to be replaced) Copyrightⓒ. 2015. All Rights Reserved.