2015.04.19 ELS 4.2 Mono Graphic Type Manual Ver. 0.
1. ELS Description & Key사내한 Function Remote control device provides customer with several functions as below Waking Tag up from sleep mode Updating new purchase image on Tag Deleting purchase image on Tag Returning a Tag to be factory settings Display Area Profile Hook Battery Cover Remo-con description LED : One of any buttons is pushed, green led turns on. After sending some data to a Tag, green led will turn off.
사내한 2. “Registration” Key Function ☜ To change purchase information on Tag, perform the following steps : 1. Put remote controller near center of Tag‟s display 2. Press and hold „Registration‟ button on remote controller until green LED off (about 0.5 seconds) 3. When Tag is successfully received „Registration‟ data from remote controller, Tag‟s display will be changed to “Connected” for a few minutes. That means Tag hides purchase image to read Tag‟s IEEE MAC address through the Barcode scanner 4.
3. “Release” Key Function사내한 ☜ To release(delete) purchase information on Tag, perform the following steps : 1. Put remote controller near center of Tag display 2. Press and hold „Release‟ button until green LED off (about 0.5 seconds) 3. If Tag was received „Reset‟ command from remote controller, Tag will delete purchase information and Tag‟s display will be changed to “Ready” 4. After step.
사내한 4. “Keep Alive” Key Function Case 1 Case 2 ☜ Case 3 To wake Tag up from sleep mode, perform the following steps : 1. Put remote controller near center of Tag display 2. Press and hold „Keep Alive‟ button until green LED off (about 0.5 seconds) 3. Tag will wake up and goes to next step.
5. “Reset” Key Function 사내한 ☜ To make a Tag to be factory reset status, perform the following steps : 1. Put remote controller near center of Tag display 2. Press and hold „Reset‟ button until green LED off (about 0.5 seconds) 3. If Tag was received „Reset‟ command from remote controller, Tag goes back to factory settings and Tag‟s display will be changed to “Ready” 4. After step.
6. Status Display 사내한 Deep Sleep mode Connected to gateway Disconnected to gateway Image downloading fail Battery is dis-charged (to need changing battery) Copyrightⓒ. 2015. All Rights Reserved.