Inside your life ! 4PPoE WLAN Bridge Manual (4PPoE: 4-Pair Power over Ethernet) [Model Name : ETPFFRPP01 ] 2020. 11. 18 .
1. Appearance Description for PoE WLAN Bridge 1. Front/Right side Panel - The Right side panel has the 2-Button and Front panel has status LEDs in the following figure. Button WPS Description • To connect WPS to AP(Access Point) RESET • Reboot • Reset to Factory Default LED Description POWER • Solid White : Power on • Off : Power is not supplied to the PoE WLAN Bridge WPS • Solid White : WLAN Activity are in process • Blinking White : Wireless data is being sent or received.
2. Left side/Back/bottom Panel & Label Information - The back panel have product label and power plug, left panel has the wireless antenna, bottom plug and 1 x RJ45 ports. - The label on the bottom shows the MAC address, serial Number. LG INNOTEK Antenna YZP-ETPFFRPP01 AC Blade 7414C-ETPFFRPP01 PoE RJ45 ETPFFRPP01 0011425000001 944444000001 Fig 2. Back/Left Side View Copyrightⓒ. 2019. All Rights Reserved. Fig 3.
2. Installation Guide 1. PoE Connection with AP 1) You can connect to AP by cellular phone ① Insert PoE WLAN Bridge to AC Power. PoE WLAN Bridge is AP mode at first. ② Turn on the WLAN in your cellular phone and search AP List. ③ Select SSID ADC_Bridge_xxx. The xxx is Mac Address final three numbers(e2b in below picture). You can check in Label ④ Open internet explorer and input any URL address. If you insert every URL, you connect PoE WLAN Bridge wep page. ⑤ Please select language.
⑦ You can see the AP List and signal strength(RSSI). Click AP SSID which is used in your test. ⑧ Click the connect message. ⑨ You will see the wait message ⑩ If you finish the process, your cellular phone disconnects from PoE WLAN Bridge. ⑪ PoE Will reboot. After a few seconds, WLAN LED will be red. The red means that PoE WLAN Bridge is connecting with AP If WLAN LED is blinking Blue, AP connection is end. ⑦ ⑧ Copyrightⓒ. 2019. All Rights Reserved.
2. PoE Connection with Power Device(Camera) ① After AP connection, You can connect PoE WLAN Bridge and Power Device(Camera) by Ethernet Cable ② Make sure that your camera is connected to the WLAN Bridge CAMERA port with an Ethernet cable(wired) CAMERA LAN Cable(CAMERA) Copyrightⓒ. 2019. All Rights Reserved.
FCC/ISED Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
FCC/ISED Statement Supplier's Declaration of Conformity 47 CFR § 2.1077 Compliance Information Responsible Party LG Innotek USA Inc. Street Address 2540 N 1st ST STE 400 SAN JOSE, CA 95131-1016 PHONE : +1-408-350-7661 / FAX : +1-408-955-0329 Copyrightⓒ. 2019. All Rights Reserved.
