& INSTALLATION INSTALLATION Tools Needed Pliers Flat-blade Screwdriver Product Specifications The appearance and specifications listed in this manual may vary due fo consent product improvements. Electrical requirements 120 VAC @ 80 Hz Fin. / Moo water pressure 20 120 psi (138 827 ia) Dimensions (M), 57 " {H with lid {door) open) B68.8 om (W) X 72,1 em (D) X 113 om (H), 145.3 em {H with lid {door) pan} Net weight 127.9 Ibs {58.
INSTALLATION 8 Choosing the Proper Location Install the washer on & solid floor that is strong and rigid enough to support the weight of the washer, even when fully loaded, without flexing or bouncing. {f the floor has toe much flex, you may dean b rain fores it fo make it more rigid. If the floor is not solid, it may cause severe vibration and noise. NOTE » Bafflers installing the washer, make sirs tha flier ia clean, dry and free of dust, dirk, wale and ol so the washer feet cannot slide easily.
46 INSTALLATION Unpacking and 2 To prevent damages, do not remove the foam il i g block containing the owner's manual, parts, and s h Nipple Material laundry product samples from the washer tub ung! Unpack all shipping materials from the washer for the washer is in the final location. proper operation and inspect it for shipping damage. AL CAUTION = Failure fo remove shipping materials can cause excessive noise and vibration. 4 Lift the washer off ths foam base.
INSTALLATION 11 Connecting the Water Lines To avoid the risk of costly waiter damage, purchase and install new inlet hoses when installing the washer. 4 Check the fittings and seals. Inspect the threaded fighting on each hose and make sure there is a nib bar seal in place in both ends of sate hose to prevent leaking. Rubber sea! Rubber less 4 Tor 108 o water inst on washer} 2 Connect the wale supply hoses.
42 INSTALLATION Connecting the Drain Hose Connect the drain hose to either a standpipe or {sundry ub. HOT » The drain hiss should always be properly secured. Failure fo progeny secure the drain hoe can result in flooding and prophesy damage. = The drain must be installed in accordance with any applicable local codes and regulations. = Make sirs that ths drain hose is nof stretched, pinched, crushed, or kinked. = Do not install the drain hose with the end lower than 28.
INSTALLATION 13 Leveling the Washer The tub of the washer aping at very high specs. To minimize vibration, noise, and unwanted movement, the floor must be a level, solid surface. NOTE = Adjust the leveling fest only as far as necessary to label the washer. Extending the invaliding fest more than necessary can cause the washer fo vibrate. = Before installing the washer, make sure that the flour is clean, dry and free of dust, dink, water and ofl 80 the washer fest cannot slide easily.
94 INSTALLATION Connecting to the Power Supply The washer should be plugged into a 120-VAC, 60 Hz grounded 3-prong loutish. Plug in the washer. AL WARNING = Do not use & wom or damaged power cord or power plug. Replace or repair it immediately. Failures to do 50 may result in death, firs, semicircle shoe, or malfunction. = Do not modify the power cord and plug provided with the appliance. Do net damage it when installing or moving the washer.