website : http://www.LGservice.com e-mail : http://www.LGEservice.com/techsup.
P roduct Feature Automatic Process From Washing To Drying. Automatic process from washing to drying can be selected easily. More economical by Intelligent Wash System Intelligent Wash System detects the amount of load and water temperature, and then determines the optimum water level and washing time to minimize energy and water consumption. Direct Drive System The advanced Brushless DC motor rotates the drum directly without belt and pulley.
I ! mportant Safety Information READ ALL INSTRUCTIONS BEFORE USE WARNING! For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. IMPORTANT SAFETY INSTRUCTIONS WARNING : To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions, including the following: • Read all instructions before using the washer.
S pecification Power plug If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or a similarly qualified person in order to avoid a hazard. Drawer (For detergent and fabric softener) Control panel Drain hose Door Drum Lower cover Adjustable feet Drain pump filter Lower cover cap Drain plug Name Power supply Size : Front-loading Washing Machine : 120V~, 60Hz : 235/8 235/8 331/2 (inches) 600 600 850 (mm) Weight : 1561/2 lbs.
I nstallation Install or store where it will not be exposed to temperatures below freezing or exposed to the weather. Properly ground washer to conform with all governing codes and ordinances. The base opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
I nstallation Installation place requirement Level floor : Allowable slope under entire washer is 1˚. Power outlet : Must be within 60 inches (1.5 m) of either side of the washer. Do not overload the outlet with more than one appliance. Additional Clearance : If the washer is installed inside a closet or alcove, the following clearances are required: 4 inches (10 cm) rear, 1 inch (2.5 cm) side Do not place or store laundry products on top of washer at any times. They can damage the finish or controls.
I nstallation Electrical connection 1. Do not use an extension cord or double adapter. 2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard. 3. Always unplug the machine and turn off the water supply after use. 4. Connect the machine to an earthed socket in accordance with current wiring regulations. 5. The appliance must be positioned so that the plug is easily accessible.
nstallation I This equipment is not designed for maritime use or for use mobile installations such as caravans, aircraft etc. Turn off the stopcock if the machine is to be left for any length of time (e.g. holiday), especially if there is no floor drain(gully) in the immediate vicinity. When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside. Packaging material (e.g. Films, Styrofoam) can be dangerous for children.
I nstallation Level adjustment 1. Leveling a the washing machine properly prevents excessive noise and vibration. Install the appliance on a solid and level floor surface, preferably in a corner of the room. Adjustable feet Higher 2. If the floor is uneven, adjust the adjustable feet as required. (Do not insert pieces of wood, etc. under the feet) Make sure that all four feets are stable and resting on the floor and then check that the appliance is perfectly level.
P reparation Before Washing WARNING - To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. 1. Care Labels Look for a care label on your clothes. This will tell you about the fabric content of your garment and how it should be washed. 2. Sorting To get the best results, Sort clothes into loads that can be washed with the same wash cycle.
A dding detergent Adding detergent and fabric softener 1. The Dispenser Drawer 3. The liquid bleach drawer. MAX • Do not open the detergent drawer during water fill cycle. • Bleach will be dispensed automatically after the detergent has had time to work. M A X max • Do not fill past MAX indicator. Detergent for wash Fabric softener Liquid Bleach 2. Adding Fabric Softener Softener level MAX MAX 125 ml 125 ml • Do not exceed the maximum fill line.
C ycles Recommended courses according to the laundry type Fabric Program Type First check if WASH laundry is machine washable. SANITARY (white cotton, linen WASH/ towel and DRY sheets...) Proper Maximum Temp. (Wash/Rinse) Load HOT/COLD Wash EXTRA RINSE 15 2/5 lbs. EXTRA WASH (7.0kg) PERM. PRESS Polyamide, Acrylic, Polyester WASH/ DRY RINSE + SPIN WOOL / SILK Time in (Option) Minutes _ Wash/Dry EXTRA RINSE 8 4/5 lbs. EXTRA WASH AUTO (TIME) (4.
H ow to use washer WASH HOT/COLD DRY ONLY WARM/WARM EXTRA WASH OPTION 1000 800 WARM/COLD EXTRA RINSE 1400 400 COLD/COLD NO SPIN TAP COLD/COLD RINSE HOLD TEMP. SPIN TIME LEFT WASH RINSE+SPIN RINSE WOOL/SILK SPIN PERM. PRESS RINSE+SPIN PERM. PRESS COTTON DRY COTTON AUTO DRY DOOR LOCK TIME DRY START/PAUSE TIME DELAY 1. Cotton automatically selected upon Power on • To start, press the POWER button. • Press the START/PAUSE button.
H ow to use washer WASH HOT/COLD WARM/WARM DRY ONLY 1400 1000 800 WARM/COLD EXTRA RINSE EXTRA WASH OPTION (1) 400 COLD/COLD NO SPIN TAP COLD/COLD RINSE HOLD TEMP. SPIN (2) (3) (1) BUTTON : OPTION (2) BUTTON : WATER TEMP. (3) BUTTON : SPIN TIME LEFT WASH RINSE+SPIN RINSE WOOL/SILK SPIN PERM.
H ow to use washer WASH/RINSE TEMPERATURE. • Press TEMP. to cycle1400 through HOT/COLD 1000 800 the temperature choices. WARM/WARM DRY ONLY DRY ONLY 400 WARM/COLD • SelectEXTRA a water RINSE temperature NO SPIN EXTRA RINSE COLD/COLD RINSE HOLD based EXTRA on the type of load you WASH EXTRA WASH TAP COLD/COLD are washing. Use the warmest waterOPTION safe for fabrics. SPIN Follow OPTION TEMP. garment label instructions. • Warm rinses leave the loads dryer than cold rinses. Warm rinses increase wrinkling.
SPIN SPIN N EXTRA RINSE NO SPIN AUTO DRY COLD/COLD RINSE HOLD EXTRA WASH TAP COLD/COLD DOOR LOCK TIME DRY START/PAUSE WASH RINSE+SPIN SPIN OPTION TEMP. WOOL/SILK TIME DELAY DRY ow to use washer H PERM.
H ow to use washer WASH WASH RINSE HOT/COLD E LEFT DRY WARM/COLD TIME LEFT DOOR LOCK AUTO DRY START/PAUSE TIME DRY COLD/COLD TAP COLD/COLD LAY TEMP. DRY RINSE SPIN WARM/WARM DRY TIME DELAY SPIN DRY • This washer-dryer’s automatic DOOR LOCK processRINSE+SPIN from washing to drying START/PAUSE WASH can be WOOL/SILK selected easily. WASH RINSE+SPIN WOOL/SILK PERM. PRESS drying, make sure • For most even DRY PERM.
NO SPIN EXTRA WASH OPTION AUTO DRY COLD/COLD RINSE HOLD SPIN DOOR L TIME DRY TAP COLD/COLD TEMP. START/ TIME DELAY DRY ow to use washer H H E PROGRAM START/PAUSE R LOCK T/PAUSE SPIN WASH RINSE+SPIN RINSE+SPIN TIME DELAY START/PAUSE PERM. PRESS WOOL/SILK COTTON PERM. PRESS COTTON SANITARY WASH/DRY SANITARY 1. Start • This START/PAUSE button is used to start wash cycle or pause the wash cycle. • 9 programs are available according1400 to 1000 800 the laundry type.
H ow to use washer DISPLAY WASH HOT/COLD WARM/WARM • When washing cycle is completed, “ ” is displayed on the “Multi DOOR LOCK display”. TIME LEFT SPIN WARM/COLD COLD/COLD 3. Completion of washing RINSE DRY AUTO DRY TIME DRY 1. Special function display TAP COLD/COLD •TEMP. When child lockTIME is selected, DELAY the “ ” is displayed. START/PAUSE WASH RINSE+SPIN 4. Time leftWOOL/SILK DRY • When time delay is selected, it shows the remaining times to finish the selected program. 2.
H ow to use washer 5. Completion of Drying • When drying cycle is completed, “ ” [COOL DOWN] is displayed on the Multi display. • The COOL DOWN is setting automatically when a drying cycle is complete. • When you are not remove a load of clothes from the dryer as soon as it stops, wrinkles can form. • The COOL DOWN operating periodically tumbles, rearranges and fluffs the load to avoid wrinkles without heat for up to 4 hours.
M aintenance ❋ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock to avoid electrical shock hazards. ❋ When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside. The water inlet filter -" " error message will blink on the control panel when water does not enter the detergent drawer.
M aintenance Dispenser drawer ❋ After a while detergents and fabric softeners leave a deposit in the drawer. • It should be cleaned from time to time with a jet of running water. • If necessary it can be removed completely from the machine by pressing the catch downward and by pulling it out. MAX • To facilitate cleaning, the upper part of the fabric softener compartment can be removed.
M aintenance Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent. Immediately wipe off any spills. Wipe with damp cloth. Try not to hit surface with sharp objects. ❋ IMPORTANT: Do not use methylated spirits, diluents or similar products. 2. Interior Dry around the washer door opening, flexible gasket and door glass. Run washer through a complete cycle using hot water.
roubleshooting guide T ❋ This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately. When the machine does not function properly or does not function at all, check the following points before you contact your service provider. Symptom Possible Cause Solution Rattling and clanking noise • Foreign objects such as coins or safety pins maybe in drum or pump. Stop washer and check drum and drain filter.
T roubleshooting guide Symptom Washer does not start Possible Cause • Electrical power cord may not be plugged in or connection may be loose. Make sure plug fits tightly in wall outlet. • House fuse blown, circuit breaker tripped,or a power outage has occurred. Reset circuit breaker or replace fuse. Do not increase fuse capacity. If problem is a circuit overload, have it corrected by a qualified electrician. Turn on water supply tap. • Water supply tap is not turned on.
roubleshooting guide T Symptom Possible Cause Solution • Water supply is not adequate in area • Water supply taps are not completely open. • Water inlet hose(s) are kinked. • The filter of the inlet hose(s) are clogged. Check another tap in the house. Fully open tap. • Drain hose is kinked or clogged. • The drain filter is clogged. Clean and straighten the drain hose. Clean the drain filter. Straighten hose(s). Check the filter of the inlet hose(s). • Load is too small.
W arranty Visit our web site at http://www.lgservice.com LG Electronics LIMITED WARRANTY United States of America LG Electronics will repair or at its option replace, without charge, your product which proves to be defective in material or workmanship under normal use during the warranty period listed below from the date of original purchase. This warranty is good only to the original purchaser of the product during the warranty period as long as it is in the U.S including Alaska, Hawaii, and U.S.
P/No.