Owner’s manual Please read this manual carefully before operating your device. The actual device may differ from the image.
Safety information CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USERSERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
CAUTION concerning the Power Cord Most appliances recommend they be placed upon a dedicated circuit; That is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner’s manual to be certain. Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed power cords, or damaged or cracked wire insulation are dangerous.
CAUTION: yy The apparatus should not be exposed to water (dripping or splashing) and no objects filled with liquids, such as vases, should be placed on the apparatus. yy Minimum distance around the apparatus for sufficient ventilation, no less than 5 cm. yy The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloth, curtains etc. yy No naked flame sources, such as lighted candles, should be placed on the apparatus.
Disposal of waste batteries/accumulators 1. When this crossed-out wheeled bin symbol is attached to batteries/ accumulators of your product it means they are covered by European Directive 2006/66/EC. 5. For more detailed information about disposal of your old batteries/ accumulators, please contact your city office, waste disposal service or the shop where you purchased the product. 2.
,,Note Device operating temperature LG Electronics hereby declares that this/these product(s) is/are in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC, 2004/108/EC, 2006/95/EC, 2009/125/EC and 2011/65/EU. Contact office for compliance of this product: LG Electronics Inc EU Representative, Krijgsman 1, 1186 DM Amstelveen, The Netherlands When operating in cold weather, the device shall not print.
Contents Safety information . . . . . . . . . . . . . . . . . . . . . . 2 STEP 1 Getting Started . . . . . . . . . . . . . . . . . . 8 Supplied items . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Product Overview . . . . . . . . . . . . . . . . . . . . . . . . 8 Power On / Off . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Installing App for iPhone . . . . . . . . . . . . . . . . 14 Setting Bluetooth of iPhone . . . . . . . . . . . . .
STEP 1 Getting Started Product Overview Reset hole Supplied items Paper exit slot LG Pocket Photo Printer USB cable Charger Paper insert door Micro USB port (for recharging) Button (Power) Paper insert slot ZINK Photo Paper 8 Owner’s manual
STEP 2 Charging Battery Power On / Off On : Press and hold for 4 sec. This device uses built-in battery. Before using it, charge the battery in full. (Refer to below) Off : Press and hold for 2 sec. ,,Note button yy When turning the device on, the flashes for 5 sec. Then printing is available. button) shows the yy The LED indicator ( device condition. For more information, see “About LED indicator” on page 22. Battery charging time : 1.
Charger (AC Adapter) yy Model : MCS-01ET yy Manufacturer : TEN PAO INTERNATIONAL LTD. yy Input : 100 - 240 V ~, 50 / 60 Hz yy Output : 5 V 0 1.2 A >>Caution y Handle with care during charging to prevent y electric shock. yy Do not place near heating appliance. yy Do not disassemble or deform. yy Do not give shock on. yy Avoid too high or low temperature or humidity. 10 ,,Note yy You can connect the device to PC using the supplied USB cable, but charging time can be longer.
STEP 3 Inserting Photo Paper 1. Open the Paper insert door. Photo Paper with White side up K IN Z 2. Unwrap the pack of the photo papers. 3. Slide Smart Sheet (Blue) and photo papers together into the Paper insert slot. Smart Sheet will be ejected automatically before first printing. yy Do not insert more than 1 pack (10 Photo papers and 1 Smart Sheet). Otherwise 2 papers may be ejected at once or paper jam may occur. yy Refill the device after using up the papers in.
Paper Jam Solution ,,Note Do not pull the paper out. Turn the device off and on again, the paper will be ejected automatically. yy Handle with care when you touch the paper not to get dirt on. If this problem is not solved, please refer to “Troubleshooting”. yy Ensure to use the papers within its valid date. >>Caution y Do not forcefully pull the paper out during y printing. It may result in malfunction. yy Once unpacked, the papers may begin to curl up after a period of time.
Using NFC Refer to “Printing using NFC” on page 16. * NFC : Near Field Communication ** GPS : Global Positioning System using a satellite App Setting For more information about the App, touch “Help”. See “Help” for details Bluetooth® Set the options in [Setting].
Installing App for iPhone From App Store Search for “LG Pocket Photo”. Using QR code Scan the QR code on the product box or the cover of this manual. Setting Bluetooth of iPhone 1. On your iPhone’s home screen, touch [Settings]. 2. Touch “Bluetooth” and touch the slider to turn Bluetooth [On]. 3. To connect your Pocket Photo device to the iPhone, turn on your device and make sure it is discoverable mode. 4. When your iPhone found the device, touch the name of Pocket Photo on the iphone screen.
STEP 5 Printing Photo Printing using Android phone Printing using Bluetooth ( Bluetooth® ) Preparation : Turn the device on, and start printing with the white LED ( button) turning on. Bluetooth® 1. Run LG Pocket Photo App on Android phone. 2. Select a photo to print, and touch [ ]. 3. Touch [OK], then it will start searching for Bluetooth devices. 4. When LG Pocket Photo is paired for the first time, [Bluetooth pairing request] appears. To start printing, touch [Pairing] or input the PIN code ‘0000’.
Printing using NFC ( ) Check whether your Android phone supports NFC first. Bluetooth® yy How to read NFC tag : Make smartphone get near to NFC tag on the device. NFC 3. Choose a photo to print and tag, then printing is started immediately. From this time, you can run the App and print a photo by just tagging. Setting Pocket Photo App of Android phone You can check remaining battery, the number of the photos printed, device version, MAC address, and change the setting of print mode, etc. 1.
2. Go to [Setting]. 3. Touch [Device Information]. Auto Exposure Corrects color in the image. (ON/OFF) Paper Full Prints without white space. (The edge of the image can be cut off.) Image Full Prints an image as a whole. (White space can occur at the edge of the paper.) Auto Power Off Set a time so that the device turns itself off. (Default is [5 min]. If you set to [Off ], the device can be on for up to 2.5 hours when fully charged.
Printing using iPhone Printing using Bluetooth ( ) Bluetooth® Preparation : Turn the device on, and start printing with the white LED ( button) turning on. 1. Run LG Pocket Photo App on iPhone. 2. Select a photo to print, and touch [ ]. 3. “Do you want to print?” message will be appeared. Touch [OK] to start printing. yy If Bluethooth is not connected, “ Paired device not found” message is appeared. (refer to the Bluetooth setting for iPhone.
Setting iPhone Pocket Photo App You can check remaining battery, the number of the photos printed, device version, MAC address, and change the setting of print mode, etc. 1. Run LG Pocket Photo App on iPhone. (To check [Device information], set to [On] the Bluetooth of iPhone.) Auto Exposure Corrects color in the image. (ON/OFF) Paper Full Prints without white space. (The edge of the image can be cut off.) Image Full Prints an image as a whole. (White space can occur at the edge of the paper.
Notes on the printing >>Caution yy The color of impression can be different between printed photo and image on smartphone’s display. yy Do not pull paper out by force during printing. yy Once the battery is fully charged, you can print up to 25 papers in a row. It depends on the battery condition. yy Do not open the paper insert door during printing. yy The Bluetooth searching and transferring may fail depending on its environment. Check the Bluetooth condition on your phone and try again.
Checking Label In case there are more than a LG Pocket Photo device, check MAC address on the product label to choose one you want to use. 3. You can find the product label. 1. Open the Paper insert door. >>Caution yy Be sure the device is off before opening. Be sure the Paper insert door is opened when you close the Upper Cover. yy It is recommended not to open the Upper cover as possible except for checking the label. 2. Open the Upper cover. yy Do not detach the black rubber pad.
About LED Indicator The LED indicator ( condition. button) shows the device Error/ On No paper, Paper jam, Cancelled, Opened, Low temperature, Unsupported file format Low battery/ To print, charge On the device. LED color 22 Condition/ Power Description Waiting/ On Waits for printing. Device turns itself off if it is left unused for a while. Full charge/ Off To print, turn on the device. Charging/ Off To print, turn on the device.
Specifications LED indicator Power / Waiting / Bluetooth transmitting / Charged / Discharged / Error / Condition of printer Photo size 50 mm x 76 mm (Dot size : 640 x 1224) Image file type/ size JPEG (Baseline) / less than 10 MB (Progressive JPEG is not supported.
Dimensions (W x D x H) 72.4 mm x 120.9 mm x 24 mm Net Weight 212 g yy Your phone may be incompatible with the device depending on its manufacturer, environment or (Android or iOS) operating system. yy Design and specifications are subject to change without prior notice. 24 Troubleshooting Symptom No power Cause / Solution The battery is discharged. Be sure the device is connected to charger or PC properly when charging. Bluetooth paring Switch Bluetooth off and on does not work well.
The paper jammed 1. Turn the device off and on before printing. again then paper is ejected automatically. The paper jammed 2. If above solution does during printing. not work, open the Upper cover and arrange the papers. Then insert them with Smart Sheet (Blue) or pull the paper out slowly and gently. The printed photo Open the Upper cover, has lines. arrange the papers and No or incomplete insert them with Smart Sheet locating at the bottom. Then image is printed. try printing again.
Device does not print. Be sure there are papers in the device. It may take time to print after Smart Sheet is ejected. Be sure the photo file is less than 10 MB. Baseline JPEG format is supported only. Device is turned off Check [Auto Power Off ] time automatically. in the App’s setting. Above solutions do Press Reset hole with a not work. pointed thing like mechanical pencil to initialize.
Україна Name and address of importer: ПІІ ‘ЛГ Електронікс Україна’, Україна, 01004, м. Київ, вул. Басейна, 4 (літера А), тел.: +38 (044) 201-43-50, факс: +38 (044) 201-43-73 Российская Федерация Импортер OOO “ЛГ Электроникс Рус” Адрес импортера : 1 43160 Российская Федерация, Московская область, Рузский район, сельское поселение Дороховское, 86 км. Минского шоссе, д.9 Адрес производителя : Л Г Электроникс (Хужоу) Инк., завод Хатаи, 516006, Китай, пров. ГуанДонг, г.
