INSTALLATION 13 INSTALLATION Before Installing the Range Make sure the range is properly installed and grounded by a qualified interrelate, according fo the installation instructions. Any adjustment and service should be performed only by qualified gas genre installers or service technicians. In the Commonwealth of Massachusetts « This product must be installed by a licensed plumbs or gas filter. « When using ball type gas shut-off valves, they must be the T-handle type.
14 INSTALLATION Installing the Range Unpacking and Moving the Range 4 CAUTION * You should use two of more people to move and install the genre. (Excessive Weight Hazard) Failure to du so can result in back or other injury. = Jo not use the door fiendish to push or pull the range during Installation or when meting the range sut for cleaning or service. Doing s can result in serious damages | tithe door of the range. Ra move packing material, tape and any temporary mislabels from your range before using.
16 INSTALLATION Installing the Anti-tip Devi's Anti tip thoracic Wal plate Sower must ante wood of congregants e The anti-dip bracket is packaged with an installation template. The inclinations include necessary information 1o complete the installation. Read and follow the range installation instruction shear. &b WARNING = Range must be soured with an approved anti-tip advice. The range could be tipped by standing, sitting or leaning on an open doer ¥ the genre or anti-tip device is nol properly installer.
INSTALLATION 17 Connecting the Range to Gas Shut off the range gas supply naive before removing the old range and slave it off until the new hulk-up has been completed. Because hard piping restricts movement of the range, the use of a CSA International-certified flexible metal appliance connector should be used unless local codes require g hard-piped connection.
18 INSTALLATION Electrical Connections Electrical Requirements 120 Volt, 80 He, properly grounded dedicated circuit protected Amp circuit breaker, or slow bl fuss. if an external electrical source is wizened, a statement that the appliance, when installed, must be clerically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, PAN 70 or the Canadian Electric Code, CASALS Grounding IMPORTANT.
INSTALLATION 18 Assembling the Surface Burners £) CAUTION Do not operate the boomers without all parts in place. Place the humeri caps and heads on the cookie. Hake sure that the caps and heads are placed in the correct lotions. There is ons small, one medium, ohe large, and one extra large boomer head and cap.
20 INSTALLATION Checking Operation of Bake / Broil Bu mars To check ignition of the Bake burner, follow the steps below 1 Remove all packing materials from inside the ova cavity. 2 Press the Bake. 350 °F appears in the display. 3 Prostheses Start. it may ake between 30 and 50 seconds for the bummer to start heating. To check ignition of the Broil bursar, follow the steps below 1 Pres the Broil. Hi appears in the display. @ Make sure the door is closed. 4 Press the Stat.