8 INSTALLATION INSTALLATION Installation Overview Please read the following installation instructions first slier purchasing this product or transporting if to another location. Check and choosy the proper location install natl-tip device Level the range Connect electric tangs Pius in the power cord Engage the anti-tip device Test run Product Specifications The appearance and specifications listed in this manual may vary dus io constant product improvements. Het wait 139.8 1b (63.3 kg) 136.2 Ib (81.
INSTALLATION 1 Before Installing the Range if you did not receive an anti-tip bracket with your — £5 WARNING purchase, cat (1-888-542-2823 in CANADA) to receive one at no cost Tip Over Hazard Pa A) WARNING A child or adult can tip the range and « The information in this manual should ba be killed. Verily the anti-tip bracket followed exactly. Failure fo do 50 may result in fire, electrical shock, properly damages, has been installed.
12 INSTALLATION Installing the Range Unpacking and Moving the Range ~~ 4h CAUTION * You should use two of more people to move and install the genre. (Excessive Weight Hazard) Failure to du so can result in back or other injury. = Jo not use the door handiness to push or pull the range during Installation or when moving the range out for cleaning or service. Doing so can result in serious damages io the door of the range. Remove packing material, tape and any temporary babyish from your tangs before using.
INSTALLATION 13 Dimensions and Clearances NOTE Save for the use of the local electrical inspector. 3 78 omy Applicable Emma electrical i a counter top outdistances | P57 gop x = a5 Countering {81.4 cm) height A =30° (782em) For USA = 3 (78.2 em) ~ 31° (78.7 om) For CANADA For installation in Canada, a free-standing range is not to be installed closer than 2" (12 mm} from any adjacent surface. (3 * Fe zem | a0 (78.2 cm) ‘Minim © Emm 222020202 EEE Minimum Dimensions = 30" (76.
14 INSTALLATION Installing the Anti-tip Devices Uss a level to check your adjustments. Place the level diagonally on the oven rack, and check seas direction ~~ 4b WARNING , folklorist. Tip Ger Hazard First check direction ©. A child or adult can tip the range and Then check direction @. If the level doesn't show level be killed. Verify the anti-tip bracket on the rack, adjust the leveling lags with a wrench. has been installed. Ensure the anti-pt bracket is engaged when the ranges ; is moved.
INSTALLATION 18 ~ 4h WARNING « Allow 210 3 {81.0 om to 31.4 cm) of slack in the fine so that the range can be moved if servicing Is aver necessary. * The power supply cord and plug should not bs modified. if it will not 7 the outlet, have a proper outlet Installed by a qualified electrician. = Using an extension cord to connect the power is prohibited. Connect the power cord and plug directly. + Electrical ground is required on this appliance.
16 INSTALLATION 3-Wire Connection : Power Cord — £5 WARNING « The middies (neutral or ground) wire, which is whits, of 8 3-wire power cord or 8 3-wits conduit has io bs convalesced to the middies post of the main terminal block. The remaining two wires of the power cord or conduit have to be connected to the outside posts of the main lamina connection block.
INSTALLATION 17 3-Wire Connection: Conduit install the consult as follows: Remove the conduit connection plate from the refer of the oven and rotate it. The conduit hole (1947) must be used. Fiat, prepare the con dull wires as shown below. 3-Wire Cons carnation ” i pita @8om) Second, install the conduit strain relief. For consult installations, purchase a strain relief and insert iin the 1%: in. (2.8 em) conduit bale.
18 INSTALLATION Engaging the Anti-tip Device Move the range close enough i the opening to plug into the receptacle. Side the range into position ensuring that the back leg slides under the anti-tip bracket. The range should sit flush against the back wall when properly installed. Carefully attempt to tip the range forward fo ensure that the anti-tip bracket is engaged property. If properly installed, the anti-tip bracket will prevent the tangs from being tipped.