Use and Care Manual
16 OPERATION
OPERATION
Getting Started
Before Using the Appliance
are properly assembled before using the
appliance.
r properly before using
the appliance. If the dust bin cover is left open,
the suction strength may deteriorate and affect
the cleaning performance.
prevent overheating. If the appliance becomes
overheated after extended use, it may
automatically turn off. If this occurs, leave the
appliance in a cool, well-ventilated area for
about an hour before turning on the power
again.
foreign object such as
a sock or stocking before using the appliance.
Any foreign object on the inlet port or extension
pipe will prevent the appliance from functioning
properly.
and humidity may cause static electricity to
accumulate on the appliance. Please contact LG
Electronics customer information center if the
problem persists.
temperatures as the battery runtime may
deteriorate severely if used at temperatures
lower than 41 °F (5°C) or higher than 100 °F
(38°C) for an extended period of time.
suck up oils or any
liquids, including water.
the appliance when
cleaning an elevated surface.
place it flat on the floor when not in use. Leaning
the appliance against a wall or chair can result in
product damage or personal injury if the
appliance falls.
brushes of the nozzles and tools free from grit,
sand, or abrasive objects.
Specifications section for battery
runtime details.
dependent on the surface
type and the suction power.
recommendations when
cleaning flooring, carpets, and rugs.
display as they may scratch these surfaces.
Assembling Attachments
Nozzles and tools can be attached to either the
product body or the end of the extension pipe.
CAUTION
with a tool connected may cause the motor to
overheat.
t-in safety device to
prevent overheating. If the appliance becomes
overheated after extended use, it may
automatically turn off. If this occurs, leave the
appliance in a cool, well-ventilated area for
about an hour before turning on the power
again.
appliance is running. Doing so may cause
product damage.
1
Insert the fully charged battery
a
into the
cavity at the bottom of the handle on the
product body.
2
Attach the nozzles, tools, or extension pipe by
sliding them onto the inlet
b
on the body
until they click into place. The nozzles and
tools can also be attached to the end of the
extension pipe
b
.
release button
c
.