Use and Care Manual

13
Before Using
•
The dust bin lid must be in place before using
the product. Otherwise, the suction strength will
deteriorate and cleaning will not be satisfactory.
•
Support the bottom of the product when cleaning
an elevated surface.
•
Store the vacuum in the charging station or at
on the oor when not in use. Leaning the vacuum
against a wall or chair can result in product
damage or personal injury if the vacuum falls.
•
Make sure that the exhaust lter is properly
assembled before using the product.
•
Environmental conditions such as temperature and
humidity may cause occasional static buildup to
accumulate on the product. If this is a persistent
issue, contact an LG Electronics customer
information center.
•
Any foreign object on the inlet port or extension
pipe will prevent the product from functioning
properly. Make sure to remove any foreign object
such as a sock or stocking before using the
product.
•
The battery runtime will be shortened after using
the product repeatedly for an extended period due
to its characteristics.
•
After extended use, all batteries experience
reduced battery life.
•
The last bar on the battery indicator begins to ash
when the battery needs to be recharged.
•
Please use the product at normal room
temperatures as the battery runtime will deteriorate
severely if used at temperatures lower than 41°F
(5°C) or higher than 100°F (38°C) for an extended
period of time.
•
Refer to product specications for battery run time
details.
•
These times are a guide only and may be shorter
for some surfaces.
•
Follow manufacturer's recommendations when
cleaning ooring, carpets, and rugs.
•
To avoid marking polished ooring, keep the nozzle
and brushes free from grit, sand, or abrasive
objects.
•
To maintain battery life on dual-battery models,
swap the positions of the two batteries periodically,
between the main body and the auxiliary charging
station.
Operation
Attaching the Wand and
Accessories
1
Attach the wand by sliding it onto the inlet on the
product body until it clicks into place. To detach
the wand, press the release button. Attach or
detach the accessories to the end of the wand in
the same way. Insert the battery into the cavity
at the back of the vacuum.
Inlet port
Extending
wand
Battery
Product
body
2
To extend the wand, press the button on the
back of the wand and slide the outer pipe until it
clicks into place at the desired length. The wand
extends in four steps.
Wand length
extension button
3
Accessories can be attached to either the
extending wand or the product body.
Extending wand
CAUTION
•
Do not use attachments to clean TVs, LCDs, or
monitors as they may scratch these surfaces.
•
Keep ngers away from pinch points when
assembling the wand or attachments.
•
If any foreign object is sucked into the inlet during
cleaning, operation of the vacuum cleaner might
stop in order to prevent damage to the body or
motor. Immediately stop using the vacuum cleaner
and remove the object before resuming cleaning.

Summary of content (7 pages)