User's Manual

User’s manual for M1
Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the use’s authority to operate the equipment
FCC- Class B
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a communications.
However, there is no guarantee that interference will not occur in particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This Mirror2 PBA is ONESOFT company designed specifically for the LG.
Compares with the previous Mirror version, This design uses the SMI's latest USB
controller chips. The Product has highly compatibility, and best performance intended
for supporting Dual-Channel SLC & MLC NAND type Flash memory(Contain the
latest 34nm flash), and it also supports USB1.1 & USB2.0. The Product delivers
extremely high data transfer rate and correct data through reliable 8-bit ECC engine
for the coverage of the MLC flash read/write disturbance.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.

Summary of content (1 pages)