Installation Manual

Levenhuk Broadway binoculars: replacement of batteries

1.5mm

2. Slightly loosen the screw with a 1.5mm screwdriver (not included in the kit). Do not remove

the screw completely because you will risk losing it.

3. Remove the battery compartment from the binoculars body. You will see a black sleeve inside.

1. Remove the plastic protective ring from the battery compartment.

PAGE 1
Levenhuk Broadway binoculars: replacement of batteries 1 1. Remove the plastic protective ring from the battery compartment. 1.5mm 2. Slightly loosen the screw with a 1.5mm screwdriver (not included in the kit). Do not remove the screw completely because you will risk losing it. 4 3. Remove the battery compartment from the binoculars body. You will see a black sleeve inside.
PAGE 2
55 4. Remove the sleeve from the battery compartment. 6 2 * LR41 7 5. Insert 2 LR41 batteries (included in the kit) into the sleeve and place it into the battery compartment as shown. The cut on the sleeve should be located exactly opposite the LED button. 8 6. Press the LED button – the light will turn on.
PAGE 3
9 10 7. Remount the battery compartment and tighten the screw. When the binoculars are not in use, install the plastic ring to avoid accidentally pressing the LED button – doing so will extend the battery life. Levenhuk, Inc. 924-D East 124th Ave. Tampa, FL 33612 USA Levenhuk® is a registered trademark of Levenhuk, Inc. © 2006–2019 Levenhuk, Inc. All rights reserved. levenhuk.