FNC-0107TX 10/100Mbps Fast Ethernet Adapter User’s Manual
FNC-0107TX 10/100Mbps Fast Ethernet Adapter FCC Warning This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
FNC-0107TX 10/100Mbps Fast Ethernet Adapter Table of Contents INTRODUCTION…………………... 4 About Fast Ethernet……………………… About Auto-negotiation………………….. About WOL (Wake-On-Lan)……………. Product Features…………………………. 4 4 5 6 INSTALLATION…………………… 7 Hardware Installation…………………….. BIOS Confiuration……………………….. Driver Installation………………………… Boot ROM Installation…………………… 7 8 8 8 TROUBLESHOOTING……………... 9 SPECIFICATIONS………………….
FNC-0107TX 10/100Mbps Fast Ethernet Adapter INTRODUCTION Thank you for choosing the Level One FNC-0107TX 10/100Mbps Fast Ethernet Adapter, the value leader among Fast Ethernet adapters for PCI−Bus personal computers. This Introduction chapter will be useful if you are new to Fast Ethernet and other new technology featured by the 10/100Mbps Fast Ethernet Adapter. Otherwise, skip ahead to the Installation chapter. About Fast Ethernet Fast Ethernet is a network technology specified by IEEE Standard 802.3u.
FNC-0107TX 10/100Mbps Fast Ethernet Adapter to choose the fastest communications capability between the two devices. About WOL (for WOL model only) WOL (Wake-On-LAN) is an ACPI function allowing a powered OFF computer to be powered ON from a remote station. ACPI (Advanced Configuration Power Interface) is a new technology and an open industry specification to provide power management support systems through hardware and operating system cooperation.
FNC-0107TX 10/100Mbps Fast Ethernet Adapter WOL has great utility in power management of PCs, workstations, and kiosks. Product Featues Designed for versatility and performance, the FNC-0107TX 10/100Mbps Fast Ethernet Adapter provides the following features: • Wake-On-LAN (WOL) provides great utility for power management of PC. • Operates in a PCI Bus Master slot of a Pentium/ Pentium-Pro/ Pentium-II computer, independent of CPU speed.
FNC-0107TX 10/100Mbps Fast Ethernet Adapter A flashing green LED indicates that the adapter is sending or receiving data. INSTALLATION Installation of a FNC-0107TX 10/100Mbps Fast Ethernet Adapter requires Hardware installation first, then BIOS and Software installation. Hardware Installation 1. Trun OFF the computer, unplug its power cord and open the computer case. 2.
FNC-0107TX 10/100Mbps Fast Ethernet Adapter BIOS Configuration Due to a fault in some Plug-n-Play BIOS programs, it happens occasionally that a newly installed adapter is assigned an Interrupt Number which is already assigned to another device. In such a case, the conflict of Interrupt Number will cause faults in the behavior of both devices. Then it is necessary to run the CMOS Setup utility, and manually assign a non-conflicting Interrupt Number.
FNC-0107TX 10/100Mbps Fast Ethernet Adapter 2. Refer to the installation procedure provided by networking operating system. TROUBLESHOOTING If you experience any problems with the adapter, first verify that the appropriate driver is loaded, that the proper grade of cable is employed for the network connection, and that the supporting hub is functioning properly. 1. Ascertain that the adapter card is fully and firmly seated in the slot connector. 2. Check the length and rating of connecting cables. 3.
FNC-0107TX 10/100Mbps Fast Ethernet Adapter SPECIFICATIONS Standards: IEEE 802.3 10BASE-T IEEE802.3u 100BASE-TX PCI Local Bus specification Rev.2.1 Host interface: PCI 2.