4K Action Camera Q3H User Manual Thank you for purchasing our products. This manual addresses the safety guidelines, warranty and operating instructions. Please review this manual thoroughly before operating your device.
CONTENTS Package Contents.............................................. 1 At a Glance......................................................... 3 Application Diagram of Assemble....................... 4 Features.............................................................. 5 LED Indicator Guide........................................... 5 Install & Take Out the Battery............................. 6 Install & Take Out the Micro SD Card................. 6 Charge the Battery....................................
Package Contents Waterproof Case Handlebar Mount Base Mount 1 Base Mount 2 Fixed Base Switch Connection 1 Switch Connection 2 Switch Connection 3 Adapter Clip1 Clip2 Helmet Base Bandages Batteries Stickers Ribbon& Wirerope Back Cover USB Cable Wiper User Manual -1-
1 x Camera 1 x Switch Connection 2 1 x Waterproof Case 1 x Switch Connection 3 2 x Batteries 1 x Adapter 1 x Handlebar Mount 1 x User Manual 1 x Base Mount 1 1 x Ribbon & Wire rope 1 x Base Mount 2 4 x Bandages 2 x Helmet Bases 2 x Clips 1 x USB Cable 1 x Back Cover 1 x Fixed Base 2 x Stickers 1 x Switch Connection 1 1 x Wiper NOTES: The Micro SD card is NOT included in the package. Micro SD card (Class 10 or higher up to 32GB) is supported.
At a Glance Screen Red Indicator UP Button DOWN Button Speaker Blue Indicator Battery Compartment OK Button WIFI Indicator Micro USB Port Micro SD Card Slot Switch/Mode Button HDOUT Port Lens -3-
Application Diagram of Assemble -4-
Features √170° wide-angle lens √2.0" display screen √Built-in WIFI & HDOUT √100 feet waterproof casing LED Indicator Guide System State Indicator Activity Power on The Blue LED indicator keeps on. Power off The Blue LED indicator flashes twice and goes out. Photo The Blue LED indicator flashes once every press on the OK button. Video/Slow motion The Blue LED indicator keeps flashing. Battery charging The Red LED indicator keeps flashing. Fully charged The Red LED indicator keeps on.
Install & Take Out the Battery Install the battery: 1) Stir downward the battery compartment cover and open it. 2) Install the battery into the camera correctly (Please mind the plus-minus hole). Take out the battery: Pull the label on the battery to take it out. Install & Take Out the Micro SD Card NOTES: • Please choose the Micro SD card over class 10. Micro SD cards up to a maximum 32GB capacity are supported.
Charge the Battery 1) Plug the small end of the USB cable into the Micro USB on the camera. 2) Plug the other end into a USB wall charger or computer (DC 5V) that is powered on. NOTE: When the camera is being charged, the Red LED indicator keeps flashing. When it is fully charged, the Red LED indicator keeps on. Use Your Q3H NOTE: Please remove the plastic protective films from the camera lens and the screen before use. Power on & off Power on/off: Press the MODE button for 2-3 seconds.
Turn on the WIFI: 1) Long press the UP button for 2 seconds after the camera is turned on, and WIFI message will appear on the screen, then the WIFI indicator will flash. 2) Go to the WIFI settings of your phone/tablet. Choose the WIFI name “Q3H” from the WIFI list and type in the password “1234567890” to connect. 3) Open the “XDV” app on your phone/tablet. Click on “Q3H” from the WIFI list, and the camera is connected to the “XDV” app on your phone/tablet.
2) Press the OK button to start recording. 3) Press the OK button to stop recording. D. Playback mode Playback photo/video files: 1) Press the MODE to switch to the file playback page. 2) Press UP/DOWN buttons to view the previous shot files. Delete photo/video files: Press the MODE button to switch to playback page, then choose the file you want to delete and press the OK button for 3-5 seconds. Remove & Share photo/video files Connect the camera with PC by the USB cable.
Parameter Settings (Bold =default) Description Mode Photo Video Slow Motion Select whether to enter photo, video or slow motion mode. 16M 12M 8M 5M 2M Select the desired resolution for photos. Close 3s 5s 10s 20s After setting the timing mode, you can see the countdown prompt on the lower left corner of the screen. Close 3S 10S 15S 20S 30S If you set auto photo, the camera will shoot a photo automatically according to the time interval you set.
Time-lapse Close 0.5S 1S 2s 5s 10s 30s 60s Time-lapse can turn a long event into short videos. Perfect for sunsets, street scenes, and more. Loop Recording Close 2 minutes 3 minutes 5 minutes If set the loop recording, you can continuously record the video of the duration you want. Slow Motion 1080P 60FPS 720P 90FPS Slow motion is perfect for capturing fast-moving activities. Recording Sound On Off Select whether the recording has sound or not.
Driving Mode On Off Light Source Frequency Auto 50Hz 60Hz If set on, this camera will automatically start recording video in the boot state. Select light source frequency according to the surrounding environment. If set on, the LED indicators will flash according to your operations. LED Indicator Light On Off Auto Shutdown Close 1 minute 3 minutes 5 minutes Select the auto shutdown time according to your needs.
Yes No Format If set Yes, all files of the Micro SD card will be deleted. (Please copy the files in the Micro SD card to avoid losing files due to formatting. If the SD card file system does not conform to the camera, you can also do the formatting operation.) Specifications Model Q3H LCD Screen 2.0" LTPS Video Recording Format MP4 Video Compression Format H.264 Memory Card Micro SD Card USB USB 2.
Size 59*41*28mm Weight 44g (without battery), 58g (with battery) Working Temperature -10℃~ +55℃ Storing Temperature -20℃~ +65℃ NOTE: Specifications could be subject to modification due to upgrading or updating, please regard the actual product as the standard form. FAQs Battery life is shorter than expected. The battery life will vary with operating temperature, resolution of photo/video and the recording time (the longer the recording time, the faster the power consumption.
Camera stops taking images or won't take images. • Make sure that the camera is not in low battery. The camera will stop taking images/videos when it is in low battery (a low battery notification will be displayed). • Make sure that the Micro SD card is over class 10 with high speed, and its capacity ranges from 8G to 32G. • Make sure that the Micro SD card is not full. The camera will stop taking images/videos if the Micro SD card is full.
5. Please keep the Micro SD card away from places where the magnetic is strong in case that the data on the Micro SD card lose. 6. During the process of charging up the battery, if the camera overheats, smokes or gives off a peculiar smell, please unplug the power immediately for fire prevention. 7. Please keep the camera away from your children when charging up the battery, for electric shock prevention. 8. Please keep the product in shady, dry and insulated places.
FCC ID:2AR5E-Q3H NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.