User's Manual

Operating Instructions 1 31082A
UNIVERSAL TRANSCEIVER
MODEL 22220
FCC ID #OBH22220
PLEASE SAVE THESE IMPORTANT SAFETY AND OPERATING INSTRUCTIONS
For correct operation of the equipment, it is important to read and be familiar
with this entire manual before installing and operating the charger.
DO NOT DISCARD THIS MANUAL AFTER READING.
LOOK FOR THIS SYMBOL TO POINT OUT SAFETY PRECAUTIONS. IT MEANS:
BECOME ALERT—YOUR SAFETY IS INVOLVED. IF YOU DO NOT FOLLOW THESE
SAFETY INSTRUCTIONS, INJURY OR PROPERTY DAMAGE CAN OCCUR.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
INSTALLATION INSTRUCTIONS
Tools needed to install Universal Transceiver Model
22220 and Base Station PC: drill, ¼" drill bit, Phillips
screwdriver, ¼ x 5" acid resistant cable ties
CAUTION: USE CAUTION WHEN WORKING
AROUND BATTERY CHARGING AREAS AND
INDUSTRIAL ENVIRONMENTS. ALWAYS WEAR
APPROVED PROTECTIVE EYEWEAR. ALWAYS
WORK IN A WELL-LIGHTED AREA. WEAR
APPROVED SAFETY SHOES. FOLLOW ALL
POSTED SAFETY WARNINGS WHEN WORKING
ON AND AROUND LADDERS. USE EXTREME
CAUTION WHEN OPERATING TOOLS. DO NOT
REST TOOLS ON TOP OF MACHINERY OR
STORAGE RACK BEAMS.
Note: Do not mount the Universal Transceiver
where water spills may occur. Do not mount
Universal Transceiver on unstable surfaces
such as rolling doors, access panels, etc.
Do not mount Universal Transceiver where it
may be struck by or interfere with the
operation of other moving objects, vehicles
or other machinery. Never mount the
Universal Transceiver near radiators,
heating sources or high temperature areas.
Never cover or obstruct fire sprinkler
systems, access panels, limit switches,
circuit breakers, light fixtures or other
installed machinery, electronic or
mechanical devices.
The Universal Transceiver unit has been designed
for optimum operation with a clear, unobstructed
"Line of Sight" signal transmission range of two
hundred feet (200') or less. When mounting the
Universal Transceiver, machinery, walls, doors and
other physical structures should be avoided in order
to achieve maximum antenna performance.
ASSEMBLY PROCEDURE –
Universal Transceiver
1. Locate a clear wall, ceiling or non-metal rack
area to mount the Universal Transceiver. The
unit should be mounted at least one foot (1')
from metal pipes or racks. Avoid mounting
Universal Transceiver near any sources of
potential noise interference such as electric
motors, fluorescent lamps, radio transmitters,
infrared devices, etc. (at least ten feet (10') of
clear area is recommended). Line of site
Exhibit 8