Set-up Guide
Getting Ready 1. Before you start Make sure your phone is compatible at jedichallenges.com/compatibility . 2.
Setting Up the Phone 1. GET YOUR COMPATIBLE PHONE READY 2. OPTIMIZING YOUR PHONE SETTINGS : (1) Make sure the phone is connected to WiFi. (1) (2) (3) (4) (5) (6) (2) Go to jedichallenges.com/app with your phone browser and follow the instructions to download, or search for the Star Wars: Jedi Challenges app on the application store on your phone.
Setting Up the Experience 2. ADJUST THE VOLUME If not set to maximum, set to maximum to insure best gaming experience. Swipe left to get to the next screen. 1. OPEN THE APP And tap the screen to continue. 3. TURN ON THE LIGHTSABER Turn on the Bluetooth on your phone, turn on the lightsaber using the power switch under its base.
4. CONNECT THE LIGHTSABER 5. CALIBRATE YOUR SABER Tap search for lightsaber. You have 10 seconds to click any lightsaber button. The lightsaber tip turns blue, which means it is connected. Swipe left to get to the next screen. • While standing in your play area, tab the calibration button • Tab the calibration button • Hold your lightsaber parallel to the floor • And follow the instructions to make a figure-eight motion until the circle gets filled in and the saber vibrates in your hand.
. PLACE YOUR TRACKING BEACON ON THE FLOOR 7. CONNECT YOUR CABLE • Insert the included AA batteries inside the Tracking beacon. • Remove your phone protective case if you have one. • Turn on the beacon to pink. • Make sure to connect the cable as on the pictures, so the • Place it on the floor in your play area. • Make sure you will be able to stand 1.2 to 1.5m / 4 - 4.5 feet away from the beacon while playing. • Swipe left to get to the next screen. 9 cable extends upwards.
8. ACCEPT DISPLAY PERMISSIONS (ON ANDROID ONLY) 9. TAKE THE PHONE TRAY OUT FROM THE HEADSET • Connect your phone to the headset to activate permissions and grant them. • Pull out the tray from the inside of the headset • Pull it out completely so you are able to insert the phone • Accept the pop up that appears. Disconnect the cable from the headset when done, and Click the cross on top right corner to continue to the next step.
10. INSERT THE PHONE IN THE CASE • Make sure the stopper is in the position indicated on the screen instructions. The position of the stopper depends on the phone model you are using. • Tap “continue” before inserting the phone inside the tray • When you see the dash-box on screen, place the phone inside the tray, face down, and close the tray. • Fasten the phone by pushing the fasteners to max position.
11. INSERT THE TRAY INSIDE THE HEADSET, Slide in the tray, screen down all the way inside until it clicks in position 13. PUT ON THE HEADSET AND START YOUR JEDI TRAINING. MAY THE FORCE BE WITH YOU! 12.
Learn the Controls of Your Gear A. Control button Use powers B. Activation Matrix Validate + Ignite A B A C C. Power Switch B A. Select Button Validate B. Back/Cancel Button C.