User's Manual

User manual
1. Wired mode connection:
Align the pogo pin female seat at the bottom of the plate with the male seat at the front end
of folio case, and connect them through mutual adsorption of magnets on both sides, and
then use them.
2. Bluetooth connection:
Two methods are described as follows:
a. Quick connect:
Duet 7 host supports fast connection function. For the first connection, first turn on the host
Bluetooth, turn the switch on the right side of folio case from the off position to the up
position, and then the white LED under the switch starts to flash. At the same time, the
following screen will appear on duet 7 host screen, and click the [connect] button to
complete the connection before use.
b. Normal connection:
For the first connection, turn the switch on the right side of folio case from the off position
up one grid, and then the white LED under the switch starts to flash. Open the Bluetooth
connection interface on duet 7 host, click and select the device "duet 7 BT" for connection,
as shown in the following figure:
When the screen as shown in the figure below appears, it indicates that the connection is
successful. Click the [done] button to start using.
Lenovo Duet 7 BT Folio

Summary of content (5 pages)