M5390 USER MANUAL
The Jabra brand is wholly owned by GN Netcom. Customer service is provided by GN Netcom. Please see details below. Australia 61 3 8823 9111 Japan 81 3 5297 7975 Austria 43 1 403 4134 P. R.
Thank you Thank you for purchasing the Jabra M5390 Multiuse headset. The Jabra M5390 Multiuse headset is supplied together with the Jabra A335w Dongle and the Jabra M5390 Multiuse base. This unique combination allows you to use one single headset for all your communication needs. The Jabra M5390 Multiuse headset connects simultaneously to mobile phones and desk phones - or to mobile phones and PC softphones. The headset base and the headset are used together with your desk phone.
2 1.
4 2. Fitting the headset 2.3 2.1 Fitting to ear 2.1 Open hinged ear hook as wide as possible. 1) 2.2 Hold headset to the ear so speaker fits comfortably and microphone points towards the mouth. 2.4 2.3 2.4 2.3 Close hinged ear hook over the ear. 2.4 Adjust ear hook for a comfortable fit. 2.5 2.5 5 6 2.2 En gli sh 3 2.6 1) Note: Fitting to left ear 2.5 Pull ear hook hinge from the slot and insert it on opposite side of headset marked with L. Perform steps 2.1 – 2.4 above.
3. Setting up your desk phone 3.1 En gli sh If your telephone has a headset port, go directly to 3.2b. 3.1 Unplug handset cord from your telephone and connect to the port on base unit marked . with 3.2a 3.2a Connect enclosed telephone cord to the now empty handset port on telephone, and to the port . on base unit marked with 3.2b 3.2b (Headset port use only) Connect enclosed telephone cord to the headset port on telephone, and to the port on base unit marked . with 3.3 3.
4.2 4.5 3.5 4.1 4.3 4.2 4.6 3.5 Turn on headset by pressing4.5 Answer/End button for 1 sec. (visual indicator will flash blue four times and headset will beep three times), or by placing headset in charge cradle. Turn off headset by pressing Answer/End button for 2 sec. (visual indicator will flash blue four times and headset will beep three times). 2 sec 3.6 3.4 Place headset in charge cradle and charge for a minimum of 30 min. before use. A full charge takes about 2 hours.
4.5 4.5 Setting transmit volume 3.10 Make a call (see section 4) to someone who can act as a test person. 3.10 En gli sh 3.11 Adjust outgoing volume with transmit volume control on base unit. Switch through the 3 settings until test person confirms the appropriate volume. 1) 4.6 3.11 4.6 3.12 4.7 Setting incoming volume 3.12 During a call, adjust incoming volume by pressing Volume button on headset. 3.13 A tone in headset will indicate when min./max. volume is reached. 4.7 1) Note: 6 3.
Setup Pairing your headset with your mobile phone NOTE: Before use, please charge your headset (see 3.4). En gli sh 4. Setting up your mobile phone Before using your Jabra M5390 Multiuse headset with a mobile phone, you need to pair it with your mobile phone. • Make sure the headset is off. • During start-up keep pressing the Answer/End button for three seconds. Alternatively remove the snap-on cover and press the reset button on the headset for three seconds.
5. Making a call from your desk phone 5.1 5.1 Put on headset. 1) 5.2 En gli sh 5.2 5.1 5.2 Lift handset from telephone, or press telephone´s “line” button if connected to the headset port. Then tap Answer/End button to transfer the call to headset. 5.2 5.4 5.35.2 5.3 5.5 5.3 Wait for dial tone, then dial number. 5.4 5.3 5.6 5.
6.2 6. Answering a call from your desk phone 5.2 6.1 Put on headset. 1) 6.2 Lift handset from telephone, or press telephone’s “line” button if connected to the headset port. Then tap Answer/End button to transfer the call to headset. En gli sh 5.1 6.2 6.1 6.3 5.2 6.3 5.3 5.3 6.4 6.4 6.5 5.4 6.3 To end call, tap the Answer/ End button on the headset and replace handset on telephone, or press telephone’s “end call” button if base is connected directly to telephone’s headset port.
Switching from headset to handset 6.5 During a call using the headset, pick up telephone handset and replace headset in charge cradle. The call will not be routed through to the telephone handset until headset is in the charge cradle. 6.5 En gli sh 1) Important: Do not replace handset on telephone as this will disconnect the call. 7.
Switching from headset to mobile phone the menu on your mobile phone to switch from headset to mobile phone during an active • Use call (see your mobile phone’s User Manual). Switching from mobile phone to headset En gli sh You can switch from your headset to your mobile phone during an active call. You might want to do this if, for example, your headset battery is running low. It is possible to switch from your mobile phone to your headset during an active call.
En gli sh 3 6.4 Staying within range The sound in your headset will deteriorate if you move beyond range.1) Move back into range to restore sound quality. If you move too far from your mobile phone, the call might be ended or re-routed to your mobile phone from the headset, depending on what mobile phone model you are using. Please see your mobile phone’s User Manual for more information on this function.
Low battery 8.3 Approx. 10 minutes before the headset runs out of battery, the visual indicator on headset will start to flash with a red light and a series of tones will be heard. If the battery runs out of power, visual indicator on headset will switch off automatically. Replace headset in charge cradle and continue the call using telephone handset. The headset contains a battery level indicator. By tapping the Vol.
7.5 Headset switch 8.5 If the headset is absent, the headset switch must be activated in order to use the handset or, if the headset is in use with another Bluetooth® device, the headset switch must be activated in order to use the handset. 8.5 En gli sh Features: Range 14 70 m headset/base headset/dongle 10 m for most mobile phones Talk time/ standby time Up to 6 hours/up to 60 hours Transmission protocol Bluetooth® Frequency band 2.
9.1 ~ 3 sec. 2 9.2 ~ 3 sec. 9.1 Under start-up, keep pressing the Answer/End button for three seconds. Alternatively, remove the snap-on cover and press the reset button on the headset for three seconds. Visual indicator on headset will light constant blue. 1) En gli sh 9. Reset/Pairing 9.2 Then press reset button on base unit for 3 seconds. Visual indicator on base unit will light constant blue. 3 9.3 Make sure headset and base are within 1 m of each other.
10. Using the Jabra M5390 Multiuse headset with multiple Bluetooth®-enabled devices En gli sh Your Jabra M5390 Multiuse headset can be paired with up to 8 devices. However, only two can be connected (paired with the headset, turned on and in range) with the headset at one time. This could be any two Bluetooth® devices (for example, a mobile phone and the Jabra M5390 Multiuse base, or the Jabra A335w Dongle and a mobile phone, or two mobile phones).
12. Switching between base and Jabra A335w Dongle in a multiuse scenario A typical multiuse scenario is to have the headset connected to one mobile phone and either the base or the dongle. If wanting to switch between base and dongle, while maintaining the mobile phone connection, just press and hold the Volume up/down button for 4 seconds. En gli sh NOTE: When multiple Bluetooth-enabled devices are paired with the headset, the Voice Dial* function will work with the last device that was paired. 13.
Q: Can I use wideband with a mobile phone or a desk phone? A: No, the headset only supports wideband with the Jabra A335w Dongle. Please see the Jabra A335w Dongle manual on CD for wideband settings. En gli sh Note: If your desk phone has a volume button, it might help to adjust it to optimize the sound quality in your headset. 14. Maintenance, safety and disposal Maintenance The ear hook can be wiped with a dry or slightly damp cloth. The cords and base unit can be dry-dusted as required.
9.x The GN 1000 Remote Handset Lifter (RHL) is an optional accessory that automatically lifts and lowers your telephone’s handset when making, answering or ending a call. 9.x En gli sh 15. Appendix – GN 1000 Remote Handset Lifter (RHL) (optional accessory) 9.x 9.x 9.x 15.1 Setting up 15.1 Attach RHL to telephone handset cradle. Connect RHL cord to AUX port on bottom of base unit. 9.x 9.x 15.2 9.x 9.x 9.x 9.x 15.3 9.x 9.x 9.x Making/answering a call 15.
© 2008 GN Netcom A/S. All rights reserved. Jabra® is a registered trademark of GN Netcom A/S. All other trademarks included herein are the property of their respective owners. The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by GN Netcom A/S is under license. (Design and specifications subject to change without notice). www.jabra.