User’s Manual BTS-110 Bluetooth Speaker Please read and follow these instructions before using your unit. www.lenco.
1. Important Don’ts Do not place naked flames, such as lighted candles on or near the product. Do not place objects filled with liquids, such as vases on or near the product. Do not use or store this product in a place where it is subject to direct sunlight, heat, excessive dust or vibration. Do not use this product with wet hands. Do not clean this product with water or other liquids. Do not block or cover the slots and holes in the product.
2. Getting Started A. Outlook and Controls: Item Description Item Description 1 Power OFF / ON 6 2 Charging LED (Red / Green) 7 AUX In (3.5mm Jack) 8 MIC (for Handset) 9 AUX Out (3.5mm Jack, Stereo output) 3 4 5 Mode LED (Blue / Red; Bluetooth / AUX In) Button (Volume Down / Previous) (Play / Pause , Searching, hand free function) 10 Button (Volume Up / Next) Micro USB (DC In for Power and Charge) B.
C. To recharge the built-in rechargeable battery: You can charge the Bluetooth Speaker’s battery in two ways: Connect Bluetooth Speaker to the Computer. Or, Use the USB power charger. (not included) D. Connection and Charging: Connect the Bluetooth Speaker’s Micro USB connector with the Computer’s USB port through USB cable (supplied). The charging LED turns ON in red light. (make sure that the computer is turned ON) The charging LED will switch to green light when it’s fully changed.
ON with flashing in once per 3 seconds, when it’s paired. (pairing need time will depend on the difference type / brand of device be used) Now, you can start to music play on your Bluetooth device when the device is in paired and show connected. (If not, select / tap the relate menu and choose “connect” to connect the Bluetooth speaker manually. It’s depended on your Bluetooth device version and designed function.
Or, press and hold the button for 3 – 4 seconds and Bluetooth Speaker will beeps, then the Bluetooth mode LED indicator will switch to Bluetooth searching from current mode. Then, activate the new wanted device’s Bluetooth function for searching and pairing. Note: The device is keep using battery energy if it is in power ON mode, Turn OFF the Bluetooth Speaker by the main power switch if you do not use the device for a while. H.
Now you can enjoy the music play from your external device through the wire connection, select to play music from your external device. To increase / decrease the music output level from Bluetooth Speaker, adjust the volume control Up / Down on your external device when using the AUX IN mode. K. Play to an external power amplifier by AUX OUT: Bluetooth speaker has design to make your power amplifier device for play music with an external Bluetooth device through reception by this Bluetooth Speaker.
No response from speaker 4. Restart the speaker by power Off and On. Specification Dimension 80 mm (H) x 73 mm (W) x 73 mm (D) (Approximate) Weight 260g (Approximate) Bluetooth Built-In Battery Power / Charging Input Audio I/O Operating Temperature 5. Specification V2.1 + EDR Supported Profile A2DP, AVRCP, HSP Connection Distance In 10 meters (open area) Lithium 3.
serial number below: Model: BTS-110 Serial number:_________________________________ Lenco offers service and warranty in accordance to European law, which means that in case of repairs (both during and after the warranty period) you should contact your local dealer. Important note: It is not possible to send products that need repairs to Lenco directly. Important note: If this unit is opened or accessed by a non-official service center in any way, the warranty expires.