User's Manual

Wireless Power Failure Sensor With Alarm
1. Use a screwdriver to remove the battery cover , Install 3 pcs "AAA" type batteries (Not
included) in the battery door, make sure in correct polarity(Fig.1).
2. Plug the AC adaptor to the DC 6V adaptor (Included), The RED indicator will be light
on, Install the unit on the area which you want to protected(Fig.2).
3.
Learning ID code to main unit
a.The wireless power failure sensor sensor output RF signal compatible trigger auto dialer
(T015S, T016S, T055S, T056S, T018S, T058S, T068S) and wireless outdoor siren
(526L, 526F, 527SL) and wireless alarm receiver(625RX) function, must learn ID code
to main unit then use. learn ID operation: First make auto dialer or wireless siren enter
learning mode (refer the their own manual), then turn switch to Sound OFF and pull
out adaptor jack from power failure sensor, you will hear the sound of telling you learn
ID code successfully.
b.After select a location, you should test the sensor transmitting range before mount it
permanently, turn local power switch to Sound OFF, turn the Chime switch to ON of
T015S, T016S main unit or press HOME button of T055S, T056S, T018S, T068S, after
60 seconds, then pull out adaptor jack from power failure sensor,, you will hear the main
unit sounds “DING DONG” chime if signal is received successfully, if not , change
location is required.
4. set the function switch to Sound ON, Sound OFF or Power OFF
Sound ON - When AC power cutting off or adaptor jack pull out from power failure
sensor, will sending wireless RF trigger signal and activates 30 seconds "Bi.Bi.Bi" alert
sound
Sound OFF - When AC power cutting off or adaptor jack pull out from power failure
sensor, will sending wireless RF trigger signal
Power OFF - Turn power off
5. When the battery power lower, the unit will "di-di" sound to remind the user replace the
new batteries.
NOTE: The unit must be plug the AC adaptor, otherwise it will not alarm at any way.
This sensor for detected power failure, when the room or living area power shut off, it will
activates 30 seconds alert and sending wireless RF signal trigger compatible receiver unit.
OPERATION
HOW IT WORKS
(Fig.1)
(Fig.2)
Model 762T
610-762XX-000R
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment