Instructions / Assembly



ThankyouforpurchasingLeickFurnitureproducts.

Contactcustomerserviceforcommentsorconcerns.

 

Sheboygan,WI920‐451‐4060info@leickfurnituresince1910.comwww.leickfurnituresince1910.com

1/

2

AssemblyInstructions,#11200IroncraftComputerDesk



Step1

Placethetopupsidedownonasoftsurface.Insert

onelegframeintothetopassemblytubes,fastenwith

twolongboltsonthesideandtwoshortboltsonthe

ends.Donottighten.

Step2

Insertthemetalrailsintothelegframe,fastenwith

two

shortbolts.Donottighten.

A:TopPanel

B:LeftSideFrame

C:RightSideFrame

D:(2)MetalRails

E:(4)LongBolts

F:(8)ShortBolts

G:(12)FlatWashers

H:(12)LockWashers

I:AllenWrench

PAGE 1
Thank you for purchasing Leick Furniture products. Contact customer service for comments or concerns. Sheboygan, WI 920‐451‐4060 info@leickfurnituresince1910.com www.leickfurnituresince1910.
PAGE 2
Step 3 Step 4 Do the same things on the other leg frame as in step 1 and step 2. Push leg frames onto the desk, make sure there is no gap when you tighten the bolts. Step 5 Step 6 Adjust levelers on the bottom of leg frames if needed. Wire management hole on back of desk: pull the disk out, run wires, and snap disk back in place.